1 February 2002 in Journal of Microscopy
1 June 2010 in Powder Diffraction
We have demonstrated that structures down to 150 nm can be visualized in X-ray projection images using nanofocus X-ray sources. Due to their unlimited depth of focus, they do not possess a limit on the specimen size. This is essential for three-dimensional tomographic imaging of samples with a diameter larger than a few microns. Further simulation studies have shown that optimization of the detector response curve and switching from a reflective X-ray target to a transmission target should allow us to reach sub-100-nm resolutions.
1 January 2010 in AIP Conference Proceedings
The characteristics of a Full‐Field X‐ray Fluorescence (FF‐XRF) set‐up for element‐specific imaging, installed at the HASYLAB synchrotron radiation source, were determined. A lateral resolution of 10 μm and limits of detection in the percentage range were found. Further potential developments in CCDs available for FF‐XRF are discussed and the use of polycapillary lenses as image transfer optics is illustrated in some explorative experiments.
15 September 2018 in International Journal of Engineering & Technology
In the given article special attention is paid to the transformation of the structure of average carbon steels, depending on technological methods of strengthening, the identification of factors influencing the emergence of high-strength structures. With the help of microstructural, X - ray phase studies, microhardness measurements of certain layers, the main technological parameters and modes of reinforcing workings have been identified, new and innovative combined technologies have been proposed. Based on the analysis of a number of existing technological methods of strengthening the surface layer of structural materials, the dynamics of transformation of their microstructures was researched. After laser treatment, due to the ultra-high velocity of cooling of crystallized volumes, due to intensive heat removal through the main volume of samples on the surface, a light zone, which is not digestible, is identified and is identified as "structurally martensitic" - gardenain, which is a kind of classical martensite. Based on the analysis of a number of existing technological methods of strengthening the surface layer of structural materials, the dynamics of transformation of their microstructures was researched.
23 November 2017 in Eastern-European Journal of Enterprise Technologies
We studied the process of cutting the worn pneumatic Bridgestone tire the size of 7.1/11.0-5 using the cutting tool made of alloys of grades R6M5 and T15K6, resulting in the obtained data array on the reduced cutting forces. Regression coefficients were calculated, which formed the basis of a mathematical model in the form of a second-order polynomial. The constructed mathematical model expresses cutting forces dependence on the totality of geometrical parameters and hardness of the cutting tool’s material and operational parameters of the cutting process. Using it can help determine the combination of optimal geometrical parameters, material of the cutting tool and operational parameters in order to ensure the minimization of cutting forces and energy consumption for the cutting process as a whole.The mathematical model was refined based on the obtained equation of cutting force dependences on tensile strength of the materials of automobile tires. The adequacy of the refined model was confirmed by estimating homogeneity of variances of the estimated and experimental values of cutting forces by using a statistical Fischer criterion. We determined effective operational parameters: spindle rotation frequency and cutting tool feed; geometrical parameters and hardness of the cutting tool’s material, which ensure minimal power consumption when cutting worn automobile tires