Gut microbiota composition is suggested to associate with coronavirus disease 2019 (COVID‐19) severity, but the impact of gut microbiota on health outcomes is largely unclear. We recruited 81 individuals from Wuhan, China, including 13 asymptomatic infection cases (Group A), 24 COVID‐19 convalescents with adverse outcomes (Group C), 31 severe acute respiratory syndrome coronavirus 2 (SARS‐CoV‐2) re‐positive cases (Group D), and 13 non‐COVID‐19 healthy controls (Group H). The microbial features of Groups A and D were similar and exhibited higher gut microbial diversity and more abundant short‐chain fatty acid (SCFA)‐producing species than Group C. Group C was enriched with opportunistic pathogens and virulence factors related to adhesion and toxin production. The abundance of SCFA‐producing species was negatively correlated, while Escherichia coli was positively correlated with adverse outcomes. All three groups (A, C, and D) were enriched with the mucus‐degrading species Akkermansia muciniphila, but decreased with Bacteroides‐encoded carbohydrate‐active enzymes. The pathways of vitamin B6 metabolic and folate biosynthesis were decreased, while selenocompound metabolism was increased in the three groups. Specifically, the secondary bile acid (BA) metabolic pathway was enriched in Group A. Antibiotic resistance genes were common among the three groups. Conclusively, the gut microbiota was related to the health outcomes of COVID‐19. Dietary supplementations (SCFAs, BA, selenium, folate, vitamin B6) may be beneficial to COVID‐19 patients.
28 October 2020 in IEEE Transactions on Nuclear Science
To fully optimize the operation of a high gain free-electron laser facility and offer opportunities for time-resolved experiments, a highly accurate synchronization between an electron bunch and a seeded laser is required. Thus, a high-precision and high-resolution beam arrival and flight time measurement system is built at the Shanghai soft X-ray free-electron laser (SXFEL) facility. For the SXFEL, a beam arrival time resolution better than 100 fs is required. A phase cavity-based detection scheme for this measurement has already been adopted at the SXFEL. To further optimize system performance, the impacts of clock jitter, trigger jitter, and signal analysis length on the measurement uncertainties are analyzed, and related subsystems are upgraded and optimized accordingly. The beam arrival time is successfully measured, and the initial measurement uncertainty is better than 45 fs. Furthermore, a dual-cavity mixing scheme is realized to measure the beam flight time or pseudo beam arrival time, and the measurement resolution of the beam flight time using this technique is 13 fs.
15 March 2024 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
High repetition rates are considered essential to meet the anticipated new demands of the free-electron laser (FEL) facility. To offer precise beam handling for high-repetition-rate FEL facilities operating in a multi bunch mode, an ultralow quality factor (Q) cavity beam position monitor (CBPM) is studied to distinguish nanosecond spaced electron bunches, enabling the independent position measurement of each bunch and reducing the contamination between bunch signals. The low-Q CBPM consists of two cavities: a reference cavity and a position cavity. The reference cavity is mainly used for bunch charge normalization, and the position cavity can measure the beam position vertically and horizontally. This paper studies the method to attain a low loaded quality factor for the CBPM and presents the design and preliminary test results. The test results show that the loaded quality factors of the reference cavity and the position cavity can both reach 13, which enables bunch position monitoring for those high repetition rate FEL facilities.
8 October 2026 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment