3D-Printing has been used to build hollow NMR tube/spinner combinations out of NMR-transparent polyamide. The whole 3D-print has been processed inside a glove box and during pauses of the 3D-printing process, all reactants for the palladium-catalyzed decarboxylative Sonogashira coupling of aryl halides with arylpropiolic acids have been inserted. Within the totally gas tight and pressure resistant tubes, a set of arylnaphthylalkynes has been synthesized and the progress of the reaction has been monitored via NMR spectroscopy. The (nonlinear) optical properties of the push–pull substituted bis(aryl)alkynes have been investigated by fluorescence spectroscopy and DFT calculations. A significant correlation between the intensity of the triple-bond stretching vibration and the calculated first hyperpolarizability is reported.
3D‐Printing with the well‐established ‘Fused Deposition Modeling’ technology was used to print totally gas‐tight reaction vessels, combined with printed cuvettes, inside the inert‐gas atmosphere of a glovebox. During pauses of the print, the reaction flasks out of acrylonitrile butadiene styrene were filled with various reactants. After the basic test reactions to proof the oxygen tightness and investigations of the influence of printing within an inert‐gas atmosphere, scope and limitations of the method are presented by syntheses of new compounds with highly reactive reagents, such as trimethylaluminium, and reaction monitoring via UV/VIS, IR, and NMR spectroscopy. The applicable temperature range, the choice of solvents, the reaction times, and the analytical methods have been investigated in detail. A set of reaction flasks is presented, which allow routine inert‐gas syntheses and combined spectroscopy without modifications of the glovebox, the 3D‐printer, or the spectrometers. Overall, this demonstrates the potential of 3D‐printed reaction cuvettes to become a complementary standard method in inert‐gas chemistry.
Coatings based on titanium nitrides, titanium carbides and silicon carbides can optimize the surface properties of titanium or silicon for various applications ranging from biocompatibility to chemical stability and durability. Here, we investigated a high power (100 W) high pulse repetition rate femtosecond laser process (λ=1030 nm, τ=750 fs, f=1 MHz) for the treatment of titanium and silicon in atmospheres of argon, nitrogen, methane, ethene and acetylene. In a nitrogen atmosphere, a homogeneous coating of TiON is formed on titanium. In an ethene/argon atmosphere coatings of TiOC and SiC are formed on Ti and Si, respectively. The process allows a fast surface transformation with a process rate of 0.33 cm2 s−1 and a high spatial resolution below 0.5 mm with a minimal heat affected zone at the same time. In contrast to low repetition rate femtosecond laser processed samples, the surfaces are more robust against mechanical impact. At the same time, the surfaces reveal a distinct microstructure in comparison to coatings obtained by vapor deposition techniques.