1 November 2005 in Tissue Engineering
The survival, proliferation, and differentiation of freshly isolated and cultured cells were studied after absorbing film-assisted laser-induced forward transfer. Rat Schwann and astroglial cells and pig lens epithelial cells were used for transfer and the cells were cultured for 2 weeks after laserpulsed transfer. All three cell types survived, proliferated, and differentiated under cell culture conditions and regained their original phenotype a few days after cell transfer. Time resolution studies have shown that the time required to accelerate the jets and droplets containing the cells was less than 1 µs and that the estimated minimum average acceleration of those ejected cells that reached a constant velocity was approximately 107 × g. This suggests that the majority of studied cells tolerated the extremely high acceleration at the beginning of the ejection and the deceleration during impact on the acceptor plate without significant damage to the original phenotype. These results suggest that the absorbing film-assisted laser-induced forward transfer technique appears to be suitable for several potential applications in tissue engineering and the biomedical tissue repair technologies.
15 September 2004 in Journal of Applied Physics
We present an investigation on absorbing film assisted laser induced forward transfer (AFA-LIFT) of fungus (Trichoderma) conidia. A KrF excimer laser beam [ (FWHM, full width at half maximum)] was directed through a quartz plate and focused onto its silver coated surface where conidia of the Trichoderma strain were uniformly spread. The laser fluence was varied in the range of and each laser pulse transferred a pixel of target material. The average irradiated area was . After the transfer procedure, the yeast extract medium covered glass slide and the transferred conidia patterns were incubated for 20 h and then observed using an optical microscope. The transferred conidia pixels were germinated and the areas of the culture medium surfaces covered by the pixels were evaluated as a function of laser fluence. As the laser fluence was increased from 0 to the transferred and germinated pixel area increased from 0 to . Further increase in fluence resulted in a drastic decrease down to an approximately constant value of . The yield of successful transfer by AFA-LIFT and germination was as much as 75% at . The results prove that AFA-LIFT can successfully be applied for the controlled transfer of biological objects.
1 January 2012 in Optical Engineering
The applicability of a femtosecond KrF laser in absorbing film-assisted, laser-induced forward transfer of living cells was studied. The absorbing materials were 50-nm-thick metal films and biomaterials (gelatine, Matrigel, each 50 μm thick, and polyhydroxybutyrate, 2 μm). The used cell types were human neuroblastoma, chronic myeloid leukemia, and osteogenic sarcoma cell lines, and primary astroglial rat cells. Pulses of a 500-fs KrF excimer laser focused onto the absorbing layer in a 250-μm diameter spot with fluence were used to transfer the cells to the acceptor plate placed at 0.6 mm distance, which was a glass slide either pure or covered with biomaterials. While the low-absorptivity biomaterial absorbing layers proved to be ineffective in transfer of cells, when applied on the surface of acceptor plate, the wet gelatine and Matrigel layers successfully ameliorated the impact of the cells, which otherwise did not survive the arrival onto a hard surface. The best short- and long-term survival rate was between 65% and 70% for neuroblastoma and astroglial cells. The long-term survival of the transferred osteosarcoma cells was low, while the myeloid leukemia cells did not tolerate the procedure under the applied experimental conditions.
14 September 2017 in Applied Physics A
1 April 2006 in Applied Surface Science
1 July 2007 in Applied Surface Science