The holy grail of achieving efficient operation of infrared (IR) rectennas continues to be the realization of a high performance rectifier. In this paper, we have fabricated metal–insulator–metal (MIM) diodes based on TiO2, ZnO, and NiO thin films using shadow mask evaporation, photolithography, and sputtering. The electron affinities of oxides have been measured by a combination of variable angle spectroscopic ellipsometry and x-ray photoelectron spectroscopy, as well as deduction from the extraction of metal/oxide barrier heights of Fowler–Nordheim tunneling plots. Our results confirm a low value for the electron affinity of NiOx of ∼2.1–2.5 eV, which correlates with the high zero-bias dynamic resistance (RD0) of ∼500 kΩ of an associated MIM diode. These values render NiOx to be unsuitable for use in a rectenna device. Better performance has been observed from diodes based on TiO2 and ZnOx films. The best rectification performance was achieved for a Au/2.6 nm ZnOx/Cr diode, scaled down to 1 μm2 device area, showing a zero-bias dynamic resistance of RD0 = 71 kΩ, zero-bias responsivity β0 = 0.28 A/W, and a coupling efficiency of ηc = 2.4 × 10−5% for rectification at 28.3 THz. The main significance of this study is that it employs a methodology whereby key parameters of the MIM stack are derived from physical measurements, which are then used to assist in the fitting of electrical current–voltage data to produce a reliable appraisal of diode performance in an IR rectenna.
1 November 1998 in Bioorganic & Medicinal Chemistry Letters
In this work, we investigate the use of post-fabrication thermal nanoconversion (TNC), using a heated scanning probe tip, to modify the magnetic properties of Ni80Fe20 elliptical nanoislands with varying aspect ratio. Despite Ni80Fe20 being unoptimized for TNC, by comparing quasistatic and dynamic magneto-optical Kerr effect microscopy measurements, we demonstrate that TNC at a contact temperature of 250 °C increases the saturation magnetization of the treated nanoislands, reaching a value close to 800 kA/m. Micromagnetic simulations of the nanoislands indicate that the TNC technique can be used to alter the remanent state, from a single domain to a vortex. These results demonstrate the opportunities afforded by TNC to modify the properties of selected areas in a thin film or a patterned sample, particularly when designing magnonic crystals and other nanomagnetic devices.