1 April 2024 in APL Materials
The preparation of ceramic materials with complex porous structures through photopolymerization-based 3D printing requires the development of stable and printable slurries. In this study, zirconium acetylacetonate was incorporated into the thiol vinyl organosilicon prepolymer to create a photosensitive Si–Zr–O–C slurry. Regarding the natural bone structures and the Tyson polygon principle, a gradient pore structure was designed and then printed using a digital light processing 3D printer. After printing, the effects of sintering temperatures on the phase composition and structure of Si–Zr–O–C ceramics were systematically investigated. Subsequently, a comparative analysis of structure and properties was performed on sintered samples with different zirconium acetylacetonate contents. The results revealed that the sample containing 30 wt. % zirconium acetylacetonate exhibited a higher compressive strength of 9.70 ± 0.28 MPa and a lower room temperature thermal conductivity of 0.528 W m−1 K−1. This study confirmed the significant potential of using 3D printing technology to prepare Si–Zr–O–C precursor ceramics with a porous structure.
1 April 2026 in AIP Advances
This study focuses on structural biomimetics, using bamboo as the biomimetic object. Owing to the porous and lightweight characteristics of bamboo, its macroscopic structure was simplified and simulated to design a pipeline. The changes in pore structure and quantity gradient (number ratio of inner-to-outer pores) parameters were imported into ABAQUS for simulation. The photopolymerization three-dimensional printing technology was used to prepare test specimens for investigating the compression performance of bamboo-like structural pipelines. Under the same pore structure, the simulation and experimental results were consistent. The pipeline structure at a quantity gradient ratio of 11:17 exhibited the most stable compression performance among different quantity gradients. Under the same quantity gradient, the optimal comprehensive compression performance and lightest material structure were achieved when the pore structure became circular. The change in the quantity gradient significantly impacted the compression performance of the pipeline. Therefore, the quantity gradient was the main factor affecting the compression performance of the pipeline.