Fanxing Li

Fanxing Li

Auto-generated profile, based on publicly available information

Fanxing Li

Shanghai Jiao Tong University

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
12 August 2024 in IEEE Transactions on Aerospace and Electronic Systems
Verified
Journal Article
Closed access
FLFanxing Li
Fanxing Li
LSLei Song
Lei Song
JXJingfeng Xie
Jingfeng Xie
BJBoqian Ji
Boqian Ji
XLXiaoqiang Lu
Xiaoqiang Lu
The flush airdata sensing system (FADS) is a measurement method that calculates aircrafts airdata by obtaining the pressure distribution from the ports. The traditional design method of port layout is to install the ports on the side of aircraft nose where the pressure is sensitive to angle of sideslip and angle of attack. Yet, for the aircraft whose surface pressure gradient with respect to angle of sideslip is rather slighter than that with respect to angle of attack, especially for blended wing body configuration, its measurement errors of angle of sideslip will increase significantly. In order to enhance the measurement accuracy, this paper proposes a resolution-based port layout design method for plane aircrafts while the traditional gradient-based design method deteriorates. Firstly, the pressure distribution of aircraft under various cases are obtained by computational fluid dynamics method, and then the feasible set of ports is introduced. Secondly, the layouts under different port counts are gained by resolution-based method and traditional method respectively. Finally, it establishes FADS to predict the angle of attack, angle of sideslip and airspeed by artificial neural network, and evaluates the performance of resolution-based method and traditional method. The result shows that, the resolution-based method obtains the optimal layout, and has a quite minor error and system uncertainty than traditional method, which effectively improves the system's accuracy.

25 March 2022 in IEEE Transactions on Instrumentation and Measurement
Verified
Journal Article
Closed access
FLFanxing Li
Fanxing Li
GLGang Lin
Gang Lin
XLXiaoqiang Lu
Xiaoqiang Lu
LSLei Song
Lei Song
Range of insensitivity is a crucial characteristic for pitot-static probe, and it is defined as the range of aerodynamic angle where the measurement error does not exceed acceptable tolerance. This article proposes a static orifice design in order to extend the range of insensitivity for static pressure measurement. The assumption of pressure in the static pressure cavity of a multiorifice pitot-static probe is empirically proposed and verified by wind tunnel test. Based on this assumption, the circumferential distribution of orifices for ten-orifice pitot-static probe is optimized using the adaptive simulated annealing (ASA) algorithm. After optimization, within −15° to −25° angle of attack (AOA) and 0°–15° angle of sideslip (AOS), the weighted static pressure coefficient error decreases from 0.0331 to 0.0249. The range of insensitivity is reduced by 5° in AOA direction but extended by 5° in AOS direction, where the experiment shows a good acceptance with numerical results.

4 November 2026 in IEEE Robotics and Automation Letters
Verified
Journal Article
Closed access
FSFangyu Sun
Fangyu Sun
GWGuanyan Wu
Guanyan Wu
YDYang Deng
Yang Deng
JCJiahao Cui
Jiahao Cui
FLFanxing Li
Fanxing Li
DZDanping Zou
Danping Zou