1 January 2022 in Ocean Engineering
20 December 2021 in Journal of the Society of Naval Architects of Korea
There have been many experimental studies on the manoeuvrability of KRISO Container Ship (KCS). However, the scale ratio of the model ship and the test procedure for each institute are slightly different, so direct comparison for the data is technically difficult to perform. This paper presents the manoeuvrability of the ship with different scale ratios: 1/65.8, 1/42.0, and 1/31.6 in model scale. KRISO conducted Free Running Model Tests (FRMT): 35°turning circle tests and 20/20(10/10) zigzag manoeuvring tests. The test results indicated that advance and tactical diameter in turning circle tests were similar, and overshoot angles in two zigzag manoeuvring tests increased as the model ship size increased. In addition, a basic concept for the FRMT method with an auxiliary X-thrust device was proposed so that the scale effect could be considered in model ship tests.
20 October 2022 in Journal of the Society of Naval Architects of Korea
The emergence of new concept ships, such as autonomous ships, has drawn much attention on the manoeuvrability of ships because of the safe navigation and operation of ships. Although the manoeuvrability of KRISO Container Ship(KCS) has been frequently reported, there have been few documents of representative manoeuvre cases conducted in various methods by one institute. This paper presents the manoeuvrability of the ship in 1/42.0 model scale by 3 methods: free running model tests, horizontal planar motion mechanism tests, and computational fluid dynamics analysis. KRISO reports KCS manoeuvre data: 35° turning circle tests and 20/20(10/10) zigzag manoeuvring tests. In addition, a simple formula for integrating and comparing manoeuvre indices, Manoeuvrability Comparing Simple Index(MCSI), is proposed.
31 October 2012 in Journal of Navigation and Port Research
20 December 2021 in Journal of the Society of Naval Architects of Korea
The manoeuvrability of a ship with an unwanted heel angle due to a maritime accident is changed from the original characteristics. The purpose of this study is to quantitatively investigate the change in the manoeuvring performance of a twin-screw ship under various hee angles and speed conditions. A series of free running model test campaigns were performed in the Ocean Engineering Basin of Korea Research Institute of Ships & Ocean Engineering (KRISO) for a twin-screw car ferry vessel. Turning circle test and zig-zag 10/10 and 20/20 tests were carried out on the heel angles of 0, -10, and -19.5 degrees. In addition, two-speed conditions were considered to understand the effect of ship speed. In order to examine the effect of the bilge keel, a heel angle of -22 degree where the bilge keel is exposed outside the water surface, was considered. Finally, the change of manoeuvring characteristics according to the heel angle for a twin-screw and a single-screw vessel is discussed.
20 December 2024 in Journal of the Society of Naval Architects of Korea
Most of the vehicle simulators, such as airplane, car, ship, have motion bases that provide the motion feelings of vehicles to the trainee or user. However, the motion base has a limit on its movement due to its constrained mechanism, so the motion generated by the motion base is somewhat different from the real vehicle motion. Instead of ‘classical washout filter’, the part 1 of this paper proposed a new motion filter: it uses the motion states as inputs, provides the method of determining parameters, homing action, and measurement method of motion fullness. Using this motion filter, this paper deals with applications to a submarine. Since a submarine simulator does not have the graphics which show the environment change, so without a motion base, the trainee in it can not feel the situation even though some instruments indicate the submarine movements. Therefore, for the purpose of the simulator training, the motion base of a submarine simulator is highly required. Part 1 of this paper has dealt with the basic theory and general applications, and this part 2 deals with the applications to a BB2 submarine.