1 February 2022 in Physics of the Dark Universe
1 March 2022 in Physics of the Dark Universe
9 December 2016 in Optics Express
ALPS II is a light shining through a wall style experiment that will use the principle of resonant enhancement to boost the conversion and reconversion probabilities of photons to relativistic WISPs. This will require the use of long baseline low-loss optical cavities. Very high power build up factors in the cavities must be achieved in order to reach the design sensitivity of ALPS II. This necessitates a number of different sophisticated optical and control systems to maintain the resonance and ensure maximal coupling between the laser and the cavity. In this paper we report on the results of the characterization of these optical systems with a 20 m cavity and discuss the results in the context of ALPS II.
4 March 2025 in Optics Express
The regeneration cavity (RC) is a critical component of the Any Light Particle Search II (ALPS II) experiment. It increases the signal from possible axions and axion-like particles in the experiment by nearly four orders of magnitude. The total round-trip optical losses of the power circulating in the cavity must be minimized in order to maximize the resonant enhancement of the cavity, which is an important figure of merit for ALPS II. Lower optical losses also increase the cavity storage time, and with the 123 meter long ALPS II RC we have demonstrated the longest storage time of a two-mirror optical cavity. We measured a storage time of 7.17±0.01ms, equivalent to a linewidth of 44.4 Hz and a finesse of 27,500 at a wavelength of 1064 nm.
10 February 2020 in EPJ Techniques and Instrumentation
Light-shining-through-a-wall experiments represent a new experimental approach in the search for undiscovered elementary particles not accessible with accelerator based experiments. The next generation of these experiments, such as ALPS II, require high finesse, long baseline optical cavities with fast length control. In this paper we report on a length stabilization control loop used to keep a 9.2 m cavity resonant. The finesse of this cavity was measured to be 101,300 ±500 for 1064 nm light. Fluctuations in the differential cavity length as seen with 1064 nm and 532 nm light were measured. Such fluctuations are of high relevance, since 532 nm light will be used to sense the length of the ALPS II regeneration cavity. Limiting noise sources and different control strategies are discussed, in order to fulfill the length stability requirements for ALPS II.
15 July 2024 in Optics Express
We describe a technique for measuring the complex reflectivity of an optical cavity with a resonant local oscillator laser and an auxiliary probe laser, each coupled via opposite ends of the cavity. A heterodyne sensing scheme is then used to observe the phase and amplitude of the interference beat-note between the promptly reflected field and the cavity-transmitted field injected through the far mirror. Since the local oscillator laser must pass through the cavity before interfering with the probe laser these measurements are not only independent of the spatial coupling of either laser to the cavity, but also obtained at the in-situ position of the cavity eigenmode. This technique was demonstrated on a 19 m cavity to measure the individual transmissivities of each of the mirrors as well as the round-trip optical losses to an accuracy of several parts per million.