1 October 2019 in Composites Science and Technology
1 January 2019 in Advances in Civil Engineering Materials
The effect of short-term aging temperature according to Superpave protocol on rheological properties of asphalt binder using thin film oven (TFO) and rolling thin film oven (RTFO) test was investigated. To evaluate these different aging conditions, two types of unmodified binders and a crumb rubber modified binder (CRMB) was used at three different aging temperatures 163°C, 177°C, and 195°C. To simulate the effect of temperature used during the preparation of CRMB in laboratory and ideal mixing temperature corresponding to 170 ± 20 cP, 177°C and 195°C has been incorporated, respectively. The rheological characterizations of these binders were obtained using dynamic shear rheometer for before and after short-term aging. On the basis of rutting parameter, nonrecoverable creep compliances (Jnr) and percent recovery (%R), as well as the RTFO aging process were found to be more effective than the TFO test for all the selected oven temperatures. However, the complex shear modulus FOOPIPEG*FOOPIPE of the base binders were equivalent to modified binders at 195°C. Additionally, on the basis of frequency sweep test and viscosity curve, the effect of short-term aging in a sample was investigated. However, at 195°C, the flow properties were significantly different for unmodified base binder, except for rubberized binders. From this study, based on its characterization, it is possible to use TFO or RTFO tests at a higher temperature to simulate the aging process for rubber modified binder to the actual hot-mix asphalt process.
1 November 2020 in Construction and Building Materials
6 February 2026 in Next Research
16 October 2026 in Journal of Building Pathology and Rehabilitation
28 August 2025 in Engineering Research Express
This study investigates the synergistic use of eggshell powder (EP) and steel slag (SS) as sustainable partial replacements for cement and fine aggregate (manufactured sand) in concrete, with the goal of enhancing mechanical performance while promoting eco-friendly construction practices through waste material utilization. In the experimental program, 10% eggshell powder was used as a cement substitute, and steel slag was incorporated as a fine aggregate replacement at 20%, 40%, and 60% levels. The mechanical properties of concrete—including compressive strength, split tensile strength, and flexural strength—were evaluated across various curing periods (7, 28, 56, and 90 days). Results showed that concrete containing 10% EP achieved mechanical properties nearly equivalent to the control mix (without EP). Moreover, when combined with up to 60% steel slag, the mix exhibited notable improvements in all measured strengths compared to both the control and other replacement levels. A scanning electron microscopic (SEM) analysis confirmed the positive microstructural development in the optimized mix, supporting the mechanical performance improvements. The combination of 10% eggshell powder and up to 60% steel slag offers a promising sustainable solution for improving concrete’s mechanical properties while utilizing industrial and agricultural waste materials. The study provides a valuable pathway toward greener and more durable concrete formulations.