23 March 2022 in Extreme Mechanics Letters
1 March 2011 in Acta Materialia
10 February 2022 in The International Journal of Advanced Manufacturing Technology
22 September 2019 in Journal of Intelligent Material Systems and Structures
One of the primary goals of the Consortium for the Advancement of Shape Memory Alloy Research and Technology is to enable the design of revolutionary applications based on shape memory alloy technology. To advance this goal and reduce the development time and required experience for the fabrication of shape memory alloy actuation systems, several modeling tools were developed for common actuator types and are discussed along with case studies, which highlight their capabilities and limitations. Shape memory alloys have many potential applications as reliable, lightweight, solid-state actuators given their ability to sustain high stresses and recover large deformations. In this article, modeling frameworks are developed for three common actuator designs: wires, lightweight, low-profile, and easily implemented; coiled springs, offering actuation strokes upward of 200% at reduced mechanical loads; and torque tubes, which can provide large actuation torques in small volumes and repeatable low-load actuation. Although the design and integration of a shape memory alloy–based actuation system requires application- and environment-specific engineering considerations, common modeling tools can significantly reduce the investment required for actuation system development and provide valuable engineering insight. This analysis presents a collection of Consortium for the Advancement of Shape Memory Alloy Research and Technology collaborative best practices to allow readers to utilize the available design tools and understand their modeling principles.
1 March 2012 in Materials Letters
5 March 2018 in Journal of Intelligent Material Systems and Structures
Shape memory alloys present a unique ability to undergo a solid-to-solid, diffusionless, reversible phase transformation. The forward phase transformation is commonly associated with transforming from the austenitic phase to the martensitic phase, while the reverse transformation is defined by going from the martensitic phase to the austenitic phase. In thermal actuation loading paths, forward transformation is generally associated with cooling, while reverse transformation is commonly associated with heating. In this article, however, it is shown that reverse transformation may occur during cooling of notched cylindrical shape memory alloy bars. The reversal in phase transformation is associated with the redistribution of stress in the shape memory alloy due to the phase transformation.