11 April 2025 in International Journal of Hydrogen Energy
1 December 2025 in Journal of Power Sources
11 March 2026 in Journal of Power Sources
11 July 2025 in ECS Meeting Abstracts
The energy system and the chemical industry of the present and future require large quantities of hydrogen. A key technology for the production of green hydrogen is polymer electrolyte membrane water electrolysis (PEMWE). However, investment costs are currently high due to the use of iridium, platinum and titanium [1]. One way to reduce costs is to decrease the amount of titanium used for the anode porous transport layer (PTL). Therefore, we addressed the question whether stainless steel can be used as a base material for anode PTLs and thus partially replace titanium. Within our study, we developed PTLs consisting of three layers. A stainless steel 316L expanded mesh serves as the base and is coated with a 60 µm thin titanium cold gas sprayed layer for corrosion protection. To prevent titanium oxidation, we applied a thin Pt layer on top and operated single cells with these PTLs for 1000 h at a maximum cell voltage of 2 V. The cell performance was in the same range as with Pt coated benchmark full titanium PTLs (Figure 1). Additionally, we analysed the effluent water from the cells via inductively coupled plasma mass spectroscopy (ICP-MS) and found no detrimental amounts of corrosion products. Also, the membrane electrode assemblies remained free from any corrosion products within the limits of energy-dispersive x-ray (EDX) spectroscopy, indicating sufficient protection against corrosion of the stainless steel base. As these PTLs still require a Pt coating, we also started to investigate a second approach of cost reduction by applying noble-metals free coatings on conventional titanium PTLs, which also enabled stable cell performance for at least 144 h. Detailed results on this approach will be available at the ECS-meeting. Figure 1: Mean I-V curves at the begin of test and after 1000 h at 2 V of two PEMWE single cells operated at 80.0 ± 1.0 °C end plate temperature with 60 ± 16 μm Ti coated 316L mesh anode PTLs compared with 360 µm Pt coated titanium felt PTLs (benchmark). Reference: [1] T. L. Doan et al., Int J Energy Res, DOI 10.1002/er.6739. Figure 1