Van der Waals epitaxy (vdWE) has drawn continuous attention, as it is unlimited by lattice-mismatch between epitaxial layers and substrates. Previous reports on the vdWE of III-nitride thin film were mainly based on two-dimensional (2D) materials by plasma pretreatment or pre-doping of other hexagonal materials. However, it is still a huge challenge for single-crystalline thin film on 2D materials without any other extra treatment or interlayer. Here, we grew high-quality single-crystalline AlN thin film on sapphire substrate with an intrinsic WS2 overlayer (WS2/sapphire) by metal-organic chemical vapor deposition, which had surface roughness and defect density similar to that grown on conventional sapphire substrates. Moreover, an AlGaN-based deep ultraviolet light emitting diode structure on WS2/sapphire was demonstrated. The electroluminescence (EL) performance exhibited strong emissions with a single peak at 283 nm. The wavelength of the single peak only showed a faint peak-position shift with increasing current to 80 mA, which further indicated the high quality and low stress of the AlN thin film. This work provides a promising solution for further deep-ultraviolet (DUV) light emitting electrodes (LEDs) development on 2D materials, as well as other unconventional substrates.
High density of defects and stress owing to the lattice and thermal mismatch between nitride materials and heterogeneous substrates have always been important problems and limit the development of nitride materials. In this paper, AlGaN light-emitting diodes (LEDs) were grown directly on a single-layer graphene-covered Si (111) substrate by metal organic chemical vapor deposition (MOCVD) without a metal catalyst. The nanorods was nucleated by AlGaN nucleation islands with a 35% Al composition, and included n-AlGaN, 6 period of AlGaN multiple quantum wells (MQWs), and p-AlGaN. Scanning electron microscopy (SEM) and electron backscatter diffraction (EBSD) showed that the nanorods were vertically aligned and had an accordant orientation along the [0001] direction. The structure of AlGaN nanorod LEDs was investigated by scanning transmission electron microscopy (STEM). Raman measurements of graphene before and after MOCVD growth revealed the graphene could withstand the high temperature and ammonia atmosphere in MOCVD. Photoluminescence (PL) and cathodoluminescence (CL) characterized an emission at ~325 nm and demonstrated the low defects density in AlGaN nanorod LEDs.
The growth of nitride on large-size and low-cost amorphous substrates has attracted considerable attention for applications in large-scale optoelectronic devices. In this paper, we reported the growth of GaN-based light-emitting diodes (LEDs) on amorphous SiO2 substrate with the use of nanorods and graphene buffer layers by metal organic chemical vapor deposition (MOCVD). The effect of different growth parameters on the morphology and vertical-to-lateral aspect ratio of nanorods was discussed by analyzing growth kinetics. Furthermore, we tuned nanorod coalescence to obtain continuous GaN films with a blue-LED structure by adjusting growth conditions. The GaN films exhibited a hexagonal wurtzite structure and aligned c-axis orientation demonstrated by X-ray diffractometer (XRD), Raman, and transmission electron microscopy (TEM) results. Finally, five-pair InGaN/GaN multi-quantum-wells (MQWs) were grown. The photoluminescence (PL) showed an intense emission peak at 475 nm, and the current–voltage (I-V) curve shows a rectifying behavior with a turn-on voltage of 5.7 V. This work provides a promising fabrication method for the large-area and low-cost GaN-based devices on amorphous substrates and opens up the further possibility of nitride integration with Si (100) complementary metal oxide semiconductor (CMOS) electronics.