16 June 2017 in IEEE Transactions on Industrial Electronics
Insulators are important equipment used to electrically isolate and mechanically hold wires in high-voltage power transmission systems. Faults caused by the deterioration of the insulators induce very serious problems to the power transmission line. Techniques were introduced for the acoustic detection of insulator faults by acoustic radiation noises. Radiation noises were measured from normal state insulators and fault state insulators in an anechoic chamber. The insulators used were two porcelain insulators, a cut-out switch, two line posters, and a lightning arrester. A new acoustic technique determines the direction of the insulator faults using source localization with three-dimensional microphone arrays. The advantage is to classify the fault state insulators without human inspection by considering the amount of total noises and 120-Hz harmonic components. The fault detection was determined by neural network to diagnose the state automatically. The proposed technique was evaluated by distinct, real datasets and the efficacy was validated. The noise source was detected with 100.0% accuracy and the classification ratio achieved 96.7% for three typical conditions.
19 May 2011 in IEEE Transactions on Instrumentation and Measurement
This paper proposes several extensive methods to predict the future location of an automobile. The goals of this paper are to find a more accurate way to predict the future location of an automobile by 3 s ahead, so that the prediction error can be greatly reduced with the innovative idea of merging global-positioning-system (GPS) data with geographic-information-system (GIS) data. The improvement starts by applying existing techniques to extrapolate the current GPS location. Comprehensive Kalman filters (KFs) are implemented to deal with inaccuracy in the different identified possible states an automobile could be found in, which are identified as constant locations, constant velocity, constant acceleration, and constant jerks. Then, the KFs are set up to be part of a interacting-multiple-model (IMM) system that provides the predicted future location of the automobile. To reduce the prediction error of the IMM setup, this paper imports an iterated geometrical error-detection method based on GIS data. The assumption that the automobile will remain on the road is made; therefore, the predictions of future locations that fall outside are corrected accordingly, making a great reduction to the prediction error. The actual experimental results validate our proposed system by reducing the prediction error to around half of what it would be without the use of GIS data.
8 January 2016 in IEEE Journal of Translational Engineering in Health and Medicine
Tumor movements should be accurately predicted to improve delivery accuracy and reduce unnecessary radiation exposure to healthy tissue during radiotherapy. The tumor movements pertaining to respiration are divided into intra-fractional variation occurring in a single treatment session and inter-fractional variation arising between different sessions. Most studies of patients' respiration movements deal with intra-fractional variation. Previous studies on inter-fractional variation are hardly mathematized and cannot predict movements well due to inconstant variation. Moreover, the computation time of the prediction should be reduced. To overcome these limitations, we propose a new predictor for intra- and inter-fractional data variation, called intra- and inter-fraction fuzzy deep learning (IIFDL), where FDL, equipped with breathing clustering, predicts the movement accurately and decreases the computation time. Through the experimental results, we validated that the IIFDL improved root-mean-square error (RMSE) by 29.98% and prediction overshoot by 70.93%, compared with existing methods. The results also showed that the IIFDL enhanced the average RMSE and overshoot by 59.73% and 83.27%, respectively. In addition, the average computation time of IIFDL was 1.54 ms for both intra- and inter-fractional variation, which was much smaller than the existing methods. Therefore, the proposed IIFDL might achieve real-time estimation as well as better tracking techniques in radiotherapy.
14 September 2015 in IEEE Transactions on Industrial Electronics
This paper investigates whether the smartphones' built-in sensors can accurately predict future trajectories for a possible implementation in a vehicle-to-vehicle (V2V) and vehicle-to-infrastructure (V2I) system. If smartphones could be used, vehicles without the V2V/V2I technology could use them to tap into the V2V/V2I infrastructure and help to populate the gap of vehicles off the V2V/V2I grid. To evaluate this, we set up a dead-reckoning system that uses Kalman filters to predict the future trajectory of a vehicle, information that could be used in a V2V/V2I system to warn drivers if the trajectories of vehicles will intersect at the same time. Then, we use a vehicle with accelerometer, GPS, and speedometer sensors mounted on it and evaluate its accuracy in predicting the future trajectory. Afterward, we place a smartphone securely on the vehicle's dashboard, and we use its internal accelerometer and GPS to feed the same dead reckoning and Kalman filter setup to predict the future trajectory of the vehicle. We end by comparing both results and evaluating if a smartphone can achieve similar accuracy in predicting the future trajectory of a vehicle. Our results show that some smartphones could be used to predict a future position, but the use of their accelerometer sensors introduces some measurements that can be incorrectly interpreted as spatial changes.
21 March 2008 in IEEE Transactions on Industrial Electronics
Viewpoint calibration is a method to manipulate hand-eye for generating calibration parameters for active viewpoint control and object grasping. In robot vision applications, accurate vision sensor calibration and robust vision-based robot control are essential for developing an intelligent and autonomous robotic system. This paper presents a new approach to hand-eye robotic calibration for vision-based object modeling and grasping. Our method provides a 1.0-pixel level of image registration accuracy when a standard Puma/Kawasaki robot generates an arbitrary viewpoint. To attain this accuracy, our new formalism of hand-eye calibration deals with a lens distortion model of a vision sensor. Our most distinguished approach of optimizing intrinsic parameters is to utilize a new parameter estimation algorithm using an extended Kalman filter. Most previous approaches did not even consider the optimal estimates of the intrinsic and extrinsic camera parameters, or chose one of the estimates obtained from multiple solutions, which caused a large amount of estimation error in hand-eye calibration. We demonstrate the power of this new method for: (1) generating 3-D object models using an interactive 3-D modeling editor; (2) recognizing 3-D objects using stereovision systems; and (3) grasping 3-D objects using a manipulator. Experimental results using Puma and Kawasaki robots are shown.
10 July 2014 in IEEE Transactions on Neural Networks and Learning Systems
Kernel association (KA) in statistical pattern recognition used for classification and prediction have recently emerged in a machine learning and signal processing context. This survey outlines the latest trends and innovations of a kernel framework for big data analysis. KA topics include offline learning, distributed database, online learning, and its prediction. The structural presentation and the comprehensive list of references are geared to provide a useful overview of this evolving field for both specialists and relevant scholars.