1 November 2017 in Construction and Building Materials
11 April 2018 in IOP Conference Series: Earth and Environmental Science
1 April 2016 in MATEC Web of Conferences
This paper presents a recycled aggregate concrete (RAC) mix that has been modified by adding treated recycled concrete aggregate (RCA) and various types of fiber-reinforced systems. The effectiveness of these modifications in terms of energy absorption and impact resistance was evaluated and compared with that of the corresponding regular concrete, as well as with unmodified RAC specimens. Results clearly indicate that although modification of the RAC mix with treated RCA significantly enhances the impact resistance of RAC, further diversification with additional fiber, particularly those in hybrid form, can optimize the results.
2 August 2016 in Key Engineering Materials
ZAZafirol Abdullah Halim Anas
Zafirol Abdullah Halim Anas
Continuous reduction of construction mineral resources, such as sand and cement, which influence the increase in cost of raw materials, has stimulated initiatives to look for alternative sustainable materials. This research aims to determine the potential and feasibility use of recycled fine aggregate (RFA) generated from demolition waste rubble wall as aggregate to replace natural sand in the production of cement and sand bricks. The brick specimens are prepared by using 100% natural sand, which is then replaced by RFA at 25%, 50%, 75%, and 100% by weight of natural sand. Research parameters, such as dimension, compressive and flexural strength, density, and water absorption, are adopted to evaluate the physical and mechanical properties of the brick specimens. In addition, the thermal conductivity of the bricks composed using different RFA proportions are studied. Experimental results clearly indicate that manufacturing cement and sand brick by incorporating RFA is possible, and the effect inclusion of RFA at certain proportions causes a significant improvement in the mechanical properties of bricks. However, to obtain better mechanical strength results, RFA dosages to replace sand should reach up to 50%.
25 March 2025 in Materiales de Construcción
This article introduces oil palm shell (OPS), an agricultural waste product, as a promising substitute for traditional aggregates in concrete. OPS exhibits lightweight characteristics, reducing the overall density of structures and aligning with sustainable building practices. Despite its advantages, OPS incorporation faces challenges, particularly in terms of durability and mechanical strength. The porous nature of OPS raises concerns about its long-term performance, susceptibility to environmental factors and impact on concrete workability. To address these challenges, this article proposes a surface treatment method using styrene acrylic emulsion (SAE) to modify the physical properties of OPS. This research aims to assess the influence of different SAE coatings on the durability properties, particularly in the permeability and dry shrinkage of OPS concrete. Results show that SAE treatment enhances particle density, reduces water absorption and improves adhesion between OPS and the cement matrix, which positively impacts concrete strength.
12 May 2020 in Materials Science Forum
This paper presents a study that aimed to assess the chloride penetration depth of recycled aggregate concrete (RAC) modified by using treated coarse recycled concrete aggregate (RCA), adding polyolefin (PO) or polypropylene (PP) fibre and comparing with normal concrete. The coupling effects of the treated RCA and fibres on the chloride penetration of RAC were analysed after two different curing regimes (i.e. normal and seawater) and tested at different curing ages (i.e. 90, 180 and 300 days). Results showed that the inclusion of treated coarse RCA can reduce porosity, thereby decreasing the chloride penetration of RAC. However, the coupling effects of treated coarse RCA and fibre, especially on the use of PO fibre, can enhance the results.