9 June 2021 in IEEE Transactions on Power Delivery
The severity evaluation of UHF signals of partial discharge in GIS is helpful to formulate a maintenance strategy in time, and improve the reliability of power system operation. Most of the evaluation methods are based on structured data, which cannot fully characterize the state of the equipment. In this paper, a method for evaluating the severity of UHF signals of partial discharge in GIS based on semantic analysis is presented. It comprehensively considers the influence of structured data and unstructured text data on the state of equipment, including measured data on partial discharge, relevant information of defects, and equipment operating parameters. Firstly, the severity of UHF signals of partial discharge is defined. According to the on-site detection of substations, a data set containing equipment detection reports and PRPS data is established. Aiming at semantic analysis, Word Embedding is used to associate and encode textual information to reduce the subjectivity of the encoding. Measured data on partial discharge is also combined and analyzed for evaluation. The method proposed is used for case analysis and compared with other methods. The results show that the comprehensive utilization of structured data and unstructured text data can reflect the state of equipment more comprehensively and truthfully, and improve the accuracy of the results.
7 November 2022 in High Voltage
The optical morphology of discharge is the main characteristic parameter describing the physical process of the discharge, and the luminescence behavior is inextricably linked to the motion behavior of charged particles. Since the Trichel discharge in air is a weak ionization event occurring on the sub‐nanosecond time scale, micron space scale and accompanied by weak luminescence, the current experimental observation means have a low spatial and temporal resolution, which is insufficient to study the details of its luminescence properties clearly. To address this problem, the intensity of light generated by Trichel discharge in air is first measured and resolved in time and space using a constructed ultrafast optical counting and imaging system. At a very high temporal resolution of 55 ps, it is found that both its light emission and current pulse showed a trend of first rapid growth and then slow decline on the time scale of tens of nanoseconds. Later, in order to further investigate the connection between the microscopic behavior of charged particles and photons, a two‐dimensional hydrodynamic simulation model with three components (electrons, positive ions, and negative ions) is developed and the current simulation results are in good agreement with the experimental results. The results show that the size of the ionization region and the interaction between particles in the discharge process are the main factors affecting the Trichel pulse and its photoemission. Electrons play a dominant role in photon generation during the rise time process, while it is the recombination process of positive and negative charges, which contributes the main photons during the fall time process. Finally, it is proposed that the expression of photon flux should be amended to include an additional term responsible for the photons generated due to recombination. The study helps to advance the understanding of the luminescence characteristics and the discharge mechanism of Trichel discharge.
10 June 2022 in IET Science, Measurement & Technology
Higher time resolution imaging is vital for exploring the microscopic mechanisms of the discharge process. The transient processes of discharge phenomena occur in a short time, and the onset cannot be predicted in advance, thus not providing a trigger mechanism for conventional high‐speed imaging methods. Here, the authors propose a high‐time‐resolution imaging method with 55‐ps time resolution and single‐photon detection sensitivity. First, the current signal generated by the discharge itself with a rising edge of only a few tens of nanoseconds combined with a high‐speed sensing and signal‐processing device is used to solve the high‐speed triggering problem, and then the single‐photon avalanche detector array operating in time‐correlated single‐photon counting mode combined with computational imaging techniques is used to obtain the evolution of the negative corona discharge at atmospheric pressure in air on the ps time scale, and finally, the time‐dependent curves of the discharge photon number at different experimental voltages with different curvature radii are analysed. The method opens up new possibilities for imaging other high‐speed dynamic processes without a fixed trigger signal.
9 August 2023 in IEEE Transactions on Dielectrics and Electrical Insulation
Metal protrusion discharge is one of the most common types of partial discharges in high-voltage equipment, and understanding the patterns of its discharge evolution is of great value in accurately assessing the severity of the discharges. Traditionally, there are problems such as unclear boundaries for the classification of different stages in the evolution of protrusion defects. The relatively low time resolution of experimental observations makes it difficult to accurately characterize single discharge processes and lacks correlations between multiple physical quantities in the evolution. To this end, an experimental platform for the joint detection of multi-physical quantities with high time resolution is first built, and the current, light and electromagnetic signals generated in each stage of the discharge process are measured simultaneously. On this basis, the variation patterns and characteristics of the characteristic parameters of multi-physics signals are summarized, and the mapping relationship between the discharge process and the characteristic quantities are established. The corresponding physical explanation and mechanism analysis are also provided. Finally, three-dimensional data characteristic values composed of current, light, and electromagnetic are comprehensively constructed to objectively classify the discharge state of protrusion defects into four levels using cluster analysis methods. The results enrich the theoretical study of the development process and evolution mechanism of the discharge, and also provide some theoretical basis and scientific reference for the assessment of the severity of the partial discharge by the actual corresponding detection means.