A new oxa-norbornene bio-based lactone obtained from the 100% atom economic reaction of furfuryl alcohol and itaconic anhydride via a tandem Diels–Alder addition and lactonisation is presented. Esterification of the resulting acid gives a monomer for the production of a bio-based polymer with low polydispersity and well controlled molecular weight via ring-opening metathesis polymerisation (ROMP).
The design and preparation of polymers by using biobased chemicals is regarded as an important strategy towards a sustainable polymer chemistry. Herein, two aromatic diols, 4-(hydroxymethyl)-2-methoxyphenol and 2-(4-(hydroxymethyl)-2-methoxyphenoxy)ethanol, have been prepared in good yields through the direct reduction of vanillin and hydroxyethylated vanillin (4-(2-hydroxyethoxy)-3-methoxybenzaldehyde) using NaBH4, respectively. The diols were submitted to traditional polycondensation and polyaddition with acyl chlorides and diisocyanatos, and serials of new polyesters and polyurethanes were prepared in high yields with moderate molecular weight ranging from 17,000 to 40,000 g mol−1. Their structures were characterized by 1H NMR, 13C NMR and FTIR, and their thermal properties were studied by TGA and differential scanning calorimetry (DSC), indicating that the as-prepared polyesters and polyurethanes have Tg in the range of 16.2 to 81.2 °C and 11.6 to 80.4 °C, respectively.
Controllable p-type doping of both poly(3-hexylthiophene) (P3HT) and poly(triarylamine) (PTAA) organic field effect transistors (OFETs) was achieved by immersing complete top-contact OFETs in a solution of 2,3,5,6-tetrafluoro-7,7,8,8-tetracyanoquinodimethane (F4-TCNQ) in acetone. As this method is applied to complete devices, it has a greater utility than methods involving doping of the solution prior to film deposition as it allows separation of the device processing and doping steps, facilitating the use of optimal processing conditions at each stage. It was found that by varying immersion time and the concentration of the dopant solution, it was possible to vary the threshold voltage for a P3HT OFET by over 30 V. Although PTAA devices are less sensitive to oxidation by F4-TCNQ than OFETs using P3HT, they can also be controllably doped by this method up to a threshold voltage of +12 V.