1 February 2006 in Advances in Water Resources
21 November 2016 in IEEE Access
We have developed a robust sensor for mounting on bridges over rivers and streams. These bridge-mounted river stage sensors (BMRSS) make periodic measurements of the distance from the sensor to the water level below. Properly interpreted, these measurements provide river-stage information, data of great importance to society and crucial to effective flood forecasting. The traditional approach to river stage measurement is the installation of pipes in rivers, digging stilling wells, and the construction of attendant brick-and-mortar infrastructure. The cost of this approach limits the deployment to larger rivers. In most instances, river-stage data from smaller tributaries are few, even though such data can greatly enhance the quality of flood-forecasting models' outputs. In contrast, BMRSS units are an order of magnitude less expensive and allow for widespread deployment. BMRSS units incorporate an ultrasonic distance-measuring module, a solar panel/battery/charge controller, and a GPS receiver. In recent years, the Internet access through commercial cellular networks has become ubiquitous, even in most rural areas. BMRSS units incorporate cell modems and transmit data through the Internet to servers at the Iowa Flood Center. Here, the data are ingested into relational databases and made available to flood forecasting models and information systems. We have deployed and operated more than 220 BMRSS units across Iowa, many for several years continuously.
15 June 2000 in Geophysical Research Letters
In support of the NASA Tropical Rainfall Measuring Mission (TRMM) Ground Validation Program, a suite of surface instruments and vertical pointing Doppler radar profilers were deployed in central Florida to quantify the number and size of the rain drops reaching the surface. Analyzing 276 minutes of simultaneous observations from two surface disdrometers and one profiler revealed good agreement among the instruments for drop sizes >1.5 mm diameter but poor agreement for smaller drop sizes. The magnitude of the difference in small drop estimation was proportional to the reflectivity (and rainrate). At reflectivities greater than 40 dBZ, the differences in the estimation of the number of small drops yielded differences in estimates of mass‐weighted diameter of > 13% and of rainrate >25%. The combined effect of these uncertainties impact the interpretation of the precipitation processes and the development and validation of space‐based precipitation retrieval algorithms.
10 April 2018 in IEEE Access
The widespread need for ubiquitous power delivery is driving the commercialization of inductive wireless power transfer (WPT). Wireless power transfer systems, however, are plagued by low efficiency. To combat this, we propose a new approach to maximize the efficiency of inductive WPT using multiple coil charging systems. The use of multiple coils can potentially allow the system to efficiently adapt to magnetic field propagation conditions, similar to the way multiple antennas are used to adapt to channel conditions in wireless communication systems. We consider a multiple-input single-output (MISO) WPT system using near-field inductive coupling. While such systems have been extensively studied in previous work using lumped resistance, inductance, and capacitance (RLC) circuit models to analyze their behavior, the difficulty of constructing tractable and realistic circuit models has limited the ability to accurately predict and optimize the performance of these systems. The main innovation in our work is to take a more abstract approach to modeling the WPT system as a linear circuit whose input-output relationship is expressed in terms of a small number of unknown parameters that can be thought of as transimpedances and gains. The crucial advantage of this approach is the economy of the representation, i.e., the number of unknown model parameters can be much smaller than the number of lumped circuit elements required for a complete and accurate RLC circuit representation. We present simple derivations for the optimal voltage excitations to be applied at the transmitters to maximize power transfer efficiency as well as suboptimal excitations which are less computationally intensive. A simple procedure, which we call circuit sounding, for estimating the unknown parameters using a small set of direct measurements is described. We outline a series of experiments with four transmit coils and two receive coils that verify the model and show that the optimal solution can achieve higher efficiencies than those of previously known methods.
29 April 2010 in Journal of Hydroinformatics
To enable the efficient use of the Hydro-NEXRAD system in hydrologic research, the authors are developing and computing a set of metadata. Vast archives of radar-centric NEXRAD data, the highly variable spatial and temporal characteristics of precipitation events, and the existence of anomalous data complicate the process of selecting subsets of the data for specific investigation. Well-defined, pre-computed, radar-centric, basin-centric and point (for a selected set of rain gauge locations) metadata offer the possibility of efficiently selecting data subsets that meet user-specified criteria. Metadata have to be computed quickly so that they do not slow down the data ingest process, but they do not have to be highly accurate. Separating rainfall from clear air conditions and heavy rainfall from light precipitation is often sufficient. In this paper, the authors discuss the technical challenges of computing metadata for the vast archives of NEXRAD data and basic data quality control incorporated into that process. Users of Hydro-NEXRAD will be able to query the database using different criteria based on the metadata or visually inspect the time series of the metadata.
18 October 2010 in IEEE Geoscience and Remote Sensing Letters
We demonstrate a new application for cellular communications equipment in monitoring vegetation. We analyze how the vegetation in a cornfield affects the received signal power recorded at cell modems in the field, and we show that the received signal power exhibited long-term and diurnal patterns related to the properties of the vegetation biomass. A novel aspect of this letter is that we recorded the signal strength data at the cellular modem in the field rather than at a cell phone tower and therefore does not require the cooperation of the cell tower owner.