Felipe Tusset

Felipe Tusset

Auto-generated profile, based on publicly available information

Felipe Tusset

Regional University of Northwestern Rio Grande do Sul State, UNIJUÍ, Panambi, Brazil

Research Focus & Metrics

Academic Career Length

1Year (2026-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 May 2026 in The International Journal of Advanced Manufacturing Technology
Verified
Journal Article
Open access
PDF file
VZVitor Zambom
Vitor Zambom
DLDalton Daniel de Lima
Dalton Daniel de Lima
Diego Tolotti de AlmeidaDiego Tolotti de Almeida
Diego Tolotti de Almeida
VBVagner Braga
Vagner Braga
FTFelipe Tusset
Felipe Tusset
CSCristiano José Scheuer
Cristiano José Scheuer
This study evaluates the effect of through-tool high-pressure coolant (HPC) on internal boring of ST52-3 steel under production-representative industrial conditions, focusing on tool wear, cutting power, surface finish, and chip evacuation. Conventional flood cooling at 20 bar was compared with through-tool HPC at 25, 40, and 50 bar in an industrial machining line. Cutting speed and depth of cut were kept constant ( v c = 220 m/min, a p = 3 mm), while the feed was increased in the HPC trials (from 0.194 to 0.265 mm/rev) to assess whether HPC could sustain more severe and potentially more productive conditions. The results showed that HPC significantly delayed flank-wear progression: the VB growth rate decreased from 0.01220 mm·part⁻¹ under conventional cooling to 0.00486, 0.00405, and 0.00311 mm·part⁻¹ at 25, 40, and 50 bar, respectively, revealing diminishing returns beyond about 40 bar. Extended tests further showed that the 40 bar condition maintained consistently lower wear up to 65 machined parts. In addition, HPC at 40 and 50 bar reduced cutting power, while 40 bar provided the most consistent chip fragmentation and evacuation. Surface roughness met the component specification after run-in for all HPC conditions, and the 40 bar condition satisfied the requirement from the first checkpoint. Overall, the study shows that through-tool HPC can improve the robustness of industrial internal boring under more demanding cutting conditions, with ~ 40 bar providing the best overall balance between tool-life extension, energetic stability, surface-finish compliance, and chip control.