Many practical applications that involve the transportation of fluid products require the use of pipeline networks. A serious problem that emerges in this kind of networks and compromises their safety and normal operation is the occurrence of leaks. Despite the fact that extensive research has been conducted over the years, relative to the development of reliable and efficient leak detection and localization systems, not so much has been presented about pipelines in high-noise environment. This article aims to contribute to the filling of this gap. To this end, a leak localization method is proposed, based on the propagation of acoustic signals in a pipeline when a leak is present. This method employs the use of accelerometers mounted on the external surface of the monitored pipeline, in order to pick up the acoustic–vibrational leak signals. These signals are segmented both in the time and frequency domains and a time-difference-of-arrival (TDOA) algorithm along with statistical analysis is used for the identification of the leak position. The objective of this is to deal with the stochastic nature and the dispersion of the leak acoustic signals and to ensure that the proposed method can easily adapt to different pipelines and can provide efficient localization accuracy even under high-noise conditions. The proposed method was tested experimentally, both in a laboratory setup and in a refinery pipeline with high ambient noise, and the results showed that it can localize leaks efficiently with an average localization error of 4.3%.
Pipeline networks are one of the most efficient and extensively used means for transporting fluid products. However, they suffer from a serious problem that threatens their normal and secure operation, which is the occurrence of leaks. In this article, an acoustic technique for the localization of leaks in pipelines placed in the high-noise environment of an oil refinery is described. This technique is based on the estimation of the time delay between the moments at which an acoustic signal produced by a leak reaches two sensors mounted on the external surface of the pipeline at a certain distance between them. For this reason, three different time delay estimation methods, based on the cross-correlation procedure, are studied in this article. These methods are tested for their accuracy in the estimation of the leak position, as well as for their ability to work with measurements of short duration and the results are compared. This is important because the acquisition duration affects directly the response time of the leak localization system, which is a crucial parameter for the targeted applications. Finally, an algorithm for fast and accurate identification of the leak point is proposed.
18 August 2022 in IEEE Transactions on Instrumentation and Measurement
A method for leak monitoring of metallic pipelines operating in the highly noisy environment of an oil refinery is proposed in this work, that can be utilized in industrial applications of similar nature. This method is based on evaluating a set of features extracted from the acquired acoustic signal of a pipeline. It relies on defining thresholds that are constantly updated based on previously acquired feature values. The algorithm behind the operation runs in short segments and produces an output based on the current feature values and their active thresholds. An occurring leak event can introduce a noticeable change in these values and cause them to exceed their specified limits. The decision about the presence of a leak and, eventually, whether a leak is detectable or not, is determined by how many and which of the features are out of the threshold limits at a given time. Some additional steps were introduced to account for random transient events that are present during noise measurements and can cause false alarms. The algorithm is associated with a set of parameters, that can be adjusted in such a way that the system can adapt to the noise characteristics of the pipeline under inspection. Also, the algorithm can begin operating after acquiring only a reference noise measurement during its initialization and without the absolute need for a training phase with artificial leaks. The proposed algorithm’s overall performance was evaluated with on-field measurements that took place on multiple operating pipelines in the facilities of an oil refinery, as well as a laboratory setting.