1 June 2012 in Acta Materialia
Commercial-purity aluminum was processed by equal-channel angular pressing (ECAP) at room temperature (RT-ECAP) and cryogenic temperature (CT-ECAP) with liquid nitrogen cooling between two successive passes. It was found that the RT-ECAPed samples showed equiaxed microstructure after 4 and 8 ECAP passes, while the CT-ECAPed samples displayed slightly elongated microstructure and slightly smaller grain size. Moreover, the CT-ECAPed samples had higher hardness values than the RT-ECAPed samples subjected to the same amount of deformation. Positron annihilation lifetime spectroscopy (PALS) was used to investigate the evolution of vacancy-type defects during the ECAP deformation process. The results showed that three types of defects existed in the ECAPed samples: vacancies associated with dislocations, bulk monovacancies and bulk divacancies. The CT-ECAPed samples had a higher fraction of monovacancies and divacancies. These two types of defects are the major vacancy-type defects that can work as dislocation pinning centers and induce hardening, resulting in higher hardness values in the CT-ECAPed samples. A quantitative relationship between material hardness and the defect concentration and defect diffusion coefficient has been established
7 September 1998 in Physical Review Letters
We observed the emission of correlated electron pairs from the valence band of solids following the absorption of single photons in the vacuum ultraviolet range. Applying a time-of-flight technique, we measured the energy distributions of correlated electron pairs emitted from clean Cu(001) and Ni(001) crystals. Significant differences between both metals were found. For the interpretation we suggest a single step two-electron-photoionization process and a competing two step mechanism involving a single photoionization and a subsequent electron-electron collision in the valence band.
1 January 2019 in Journal of Luminescence
18 September 1995 in Physical Review Letters
We report on the first measurements of the angle resolved energy distribution of correlated electrons created in single scattering events by low energy ( –25 eV) electrons. We combined coincidence and time-of-flight techniques to measure simultaneously energies and momenta of both scattered electrons of the correlated pair. The measurements were performed in the backscattering geometry on a single crystal W(100) and a thin film of LiF. We found that the most probable energy distribution of electron pairs corresponds to a constant sum of energies of both electrons.
1 December 1997 in Applied Physics A
15 December 1998 in Physical Review B
The simultaneous ejection of two electrons from the (001) surface of W due to the collision of incident low-energy electrons with valence electrons has been studied experimentally and theoretically. Energy and momenta of the ejected electrons were measured simultaneously by a combination of coincidence and time-of-flight techniques. Calculations were performed in a relativistic distorted-wave Born approximation including exchange, in which the primary electron and the two emitted electrons are described by quasiparticle multiple scattering states. The valence electron is represented by linear combinations of Bloch waves matched at the surface. Screened Coulomb interaction matrix elements between these four states are evaluated. Experimental and calculated energy distributions from W(001) for very-low-energy primary electrons at normal and grazing incidence are in fairly good overall agreement. Although some features of one-dimensional bulk densities of states are roughly reflected, Coulomb matrix elements with low-energy-electron-diffraction-type states play a vital role. Further analysis reveals in detail the importance of elastic scattering of the primary electron and of the two ejected electrons. Some observed features can be attributed to occupied surface states.