1 April 2019 in Surface and Coatings Technology
12 December 2018 in ACS Sustainable Chemistry & Engineering
1 February 2018 in Materials & Design
This paper is in closed access until 8th Dec 2018.© 2017 Elsevier Ltd Ice accretion and accumulation pose serious challenges for maintaining the operation and performance of outdoor facilities in cold climate. Epoxy resin, with a wide range of formulation possibilities, is widely used as protective coatings for outdoor facilities. However, bisphenol A (BPA), a key ingredient of conventional epoxy, is known to interfere with human's natural hormones and cause various disorders in the body system. Reduction or complete elimination of the usage of BPA is therefore high in the agenda of the coatings industries. In this study, a transparent, anti-icing, bio-based ep oxy coating was developed for room-temperature processing. As a result of hydrophobic treatment with addition of silanes, the glass-transition temperature and anti-icing performance of bio-based epoxy resin increased significantly. The optimum coating exhibited good water repellency and ice-adhesion strength as low as 50 kPa at − 20°, which was half of the widely accepted threshold value of 100 kPa for icephobic coatings. The icing delay time was much delayed compared with that of an uncoated glass substrate. To further demonstrate the anti-icing performance of the optimized coating, supercooled-water dripping on coated wooden outdoor floors and wooded boards was conducted at − 15 °C, superior anti-icing performance was observed on the coated substrates
4 November 2019 in ACS Sustainable Chemistry & Engineering
1 November 2019 in Progress in Organic Coatings
13 November 2023 in The Journal of Chemical Physics
Many modern anti-icing and anti-fouling coatings rely on soft, low surface energy elastomeric materials such as polydimethylsiloxane for their functionality. While the low surface energy is desirable for reducing adhesion, very little work considers the larger contribution to adhesive failure caused by the viscoelastic nature of elastomers. Here we examine several different siloxane elastomers using a JKR adhesion test, which was operated over a range of different speeds and temperatures. Additionally, we characterize the dynamic mechanical modulus over a large range of frequencies for each material. We note that surface energies of the materials are all similar, but variation in adhesion strength is clear in the data. The variation at low speeds is related to elastomer architecture but the speed dependence itself is independent of architecture. Qualitative correlations are noted between the JKR adhesion measurements and the dynamic moduli. Finally, an attempt is made to directly compare moduli and adhesion through the recent Persson–Brener model. Approximations of the model are shown to be inaccurate. The full model is found to be accurate at low speeds, although it fails to precisely capture higher speed behaviour.