1 February 2009 in Energy Procedia
JBJohannes Bolhàr-Nordenkampf
Johannes Bolhàr-Nordenkampf
+1
A first experimental campaign has been conducted at a 120 kW fuel power dual circulating fluidized bed installation for chemical looping combustion of gaseous fuels. In these test runs natural ilmenite (FeTiO3) has been used as oxygen carrier material. The plant consists of two interconnected circulating fluidized bed reactors (stainless steel construction, inner diameter: 0.15 m, height: air reactor 4.1 m, fuel reactor 3 m). Variations of fuel composition (natural gas, synthetic gas mixtures of H2 and CO), load, temperature and solids circulation rate have been performed for the bulk bed material. Further, natural olivine, (Fe,Mg)2SiO4, has been studied as an additive to increase hydrocarbon conversion. Despite the limited height of the risers, the results show reasonable fuel conversion for CO and H2 at 950 ∘C. The conversion of natural gas, i:e. CH4, on the other hand, is relatively low for the pure ilmenite material at about 30–40%. A certain dependency of fuel conversion on load is found especially for CH4. Addition of natural olivine results in a moderate increase of CH4 conversion
1 November 2015 in Applied Energy
1 January 2014 in Energy Procedia
This paper reports on the main results of the EU-financed project INNOCUOUS (Innovative Oxygen Carriers Uplifting Chemical-Looping Combustion). The project follows a series of successful projects with the aim of developing chemical-looping combustion (CLC) with gaseous fuels rich in methane. The project has included a wide range of experimental and modelling tasks, which included i) extensive screening of spray-dried and impregnated oxygen carriers, ii) production of impregnated and spray-dried oxygen carriers at >100kg scale, iii) operation of several oxygen carriers at industrial conditions up to 120kW scale and iv) techno-economic study of the next-scale CLC. One area of focus in the project has been the search for viable oxygen carriers which have low or no Ni. A large portfolio of interesting metal oxide systems has been found. Two oxygen carriers of CaMnxTiyMg1-x-yO3 were successfully produced in larger amounts by spray-drying and an oxygen carrier of Fe2O3/Al2O3 was produced in similar quantity using impregnation. The Ca-based material showed excellent behavior in a 10kW and 120kW unit, where complete combustion was achieved. With respect to the aim of replacing the bench-mark Ni-based material the project was thus very successful, as complete combustion has never been achieved in these units using Ni-based material
1 May 2015 in Applied Energy
1 January 2019 in Chemical Engineering Science