Lloyd E. Metzger

Lloyd E. Metzger

Auto-generated profile, based on publicly available information

Lloyd E. Metzger

Department of Dairy and Food Science, Midwest Dairy Foods Research Center, South Dakota State University, Brookings, SD 57007; Valley Queen Cheese, Milbank, SD 57252

Research Focus & Metrics

Academic Career Length

19Years (2008-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
7 March 2008 in Comprehensive Reviews in Food Science and Food Safety
Verified
Journal Article
Closed access
PDF file
RKRohit Kapoor
Rohit Kapoor
LMLloyd E. Metzger
Lloyd E. Metzger

1 June 2015 in Journal of Dairy Science
Verified
Journal Article
Open access
CMChenchaiah Marella
Chenchaiah Marella
PSP. Salunke
P. Salunke
ABA.C. Biswas
A.C. Biswas
AKA. Kommineni
A. Kommineni
LML.E. Metzger
L.E. Metzger
Dried milk protein concentrate is produced from skim milk using a combination of processes such as ultrafiltration (UF), evaporation or nanofiltration, and spray drying. It is well established that dried milk protein concentrate (MPC) that contains 80% (MPC80) and greater protein content (relative to dry matter) can lose solubility during storage as a result of protein-protein interactions and formation of insoluble complexes. Previous studies have shown that partial replacement of calcium with sodium improves MPC80 functionality and prevents the loss in solubility during storage. Those studies have used pH adjustment with the addition of acids, addition of monovalent salts, or ion exchange treatment of UF retentate. The objective of this study was to use carbon dioxide to produce MPC80 with improved functionality. In this study, reduced-calcium MPC80 (RCMPC) was produced from skim milk that was subjected to injection of 2,200 ppm of CO2 before UF, along with additional CO2 injection at a flow rate of 1.5 to 2 L/min during UF. A control MPC80 (CtrlMPC) was also produced from the same lot of skim milk without injection of CO2. The above processes were replicated 3 times, using different lots of skim milk for each replication. All the UF retentates were spray dried using a pilot-scale dryer. Skim milk and UF retentates were tested for ζ-potential (net negative charge), particle size, and viscosity. All the MPC were stored at room (22±1°C) and elevated (40°C) temperatures for 6 mo. Solubility was measured by dissolving the dried MPC in water at 22°C and at 10°C (cold solubility). Injection of CO2 and the resultant solubilization of calcium phosphate had a significant effect on UF performance, resulting in 10 and 20% loss in initial and average flux, respectively. Processing of skim milk with injection of CO2 also resulted in higher irreversible fouling resistances. Compared with control, the reduced-calcium MPC had 28 and 34% less ash and calcium, respectively. Injection of CO2 resulted in a significant decrease in ζ-potential and a significant increase in the size of the casein micelle. Moreover, RCMPC had a significantly higher solubility after storage at room temperature and at elevated temperature. This study demonstrates that MPC80 with a reduced calcium and mineral content can be produced with injection of CO2 before and during UF of skim milk.


1 October 2022 in Journal of Dairy Science
Verified
Journal Article
Open access
PSPrafulla Salunke
Prafulla Salunke
CMC. Marella
C. Marella
JAJayendra Amamcharla
Jayendra Amamcharla
KMK. Muthukumarappan
K. Muthukumarappan
LML.E. Metzger
L.E. Metzger
The amount of intact casein provided by dairy ingredients is a critical parameter in dairy-based imitation mozzarella cheese (IMC) formulation because it has a significant effect on unmelted textural parameters such as hardness. From a functionality perspective, rennet casein (RCN) is the preferred ingredient. Milk protein concentrate (MPC) and micellar casein concentrate (MCC) cannot provide the required functionality due to the higher steric stability of casein micelle. However, the use of transglutaminase (TGase) has the potential to modify the surface properties of MPC and MCC and may improve their functionality in IMC. The objective of this study was to determine the effect of TGase-treated MPC and MCC powders on the unmelted textural properties of IMC and compare them with IMC made using commercially available RCN. Additionally, we studied the degree of crosslinking by TGase in MPC and MCC retentates using capillary gel electrophoresis. Three lots of MCC and MPC retentate were produced from pasteurized skim milk via microfiltration and ultrafiltration, respectively, and randomly assigned to 1 of 3 treatments: no TGase (control); low TGase: 0.3 units/g of protein; and high TGase: 3.0 units/g of protein, followed by inactivation of enzyme (72°C for 10 min), and spray drying. Each MCC, MPC, and RCN was then used to formulate IMC that was standardized to 21% fat, 1% salt, 48% moisture, and 20% protein. The IMC were manufactured by blending, mixing, and heating ingredients (4.0 kg) in a twin-screw cooker. The capillary gel electrophoresis analysis showed extensive inter- and intramolecular crosslinking. The IMC formulation using the highest TGase level in MCC or MPC did not form an emulsion because of extensive crosslinking. In MPC with a high level of TGase, whey protein and casein crosslinking were observed. In contrast, crosslinking and hydrolysis of proteins were observed in MCC. The IMC made from MCC powder had significantly higher texture profile analysis hardness compared with the corresponding MPC powder. Further, many-to-one (multiple) comparisons using the Dunnett test showed no significant differences between IMC made using RCN and treatment powders in hardness. Our results demonstrated that TGase treatment causes crosslinking hydrolysis of MCC and MPC at higher TGase levels, and MPC and MCC have the potential to be used as ingredients in IMC applications.

1 December 2019 in Journal of Dairy Science
Verified
Journal Article
Closed access
DMD.S. Mehta
D.S. Mehta
LML.E. Metzger
L.E. Metzger
AHA.N. Hassan
A.N. Hassan
BNB.K. Nelson
B.K. Nelson
HPH.A. Patel
H.A. Patel
Spore formers are common spoilage-causing microorganisms in dairy products; however, their modes of spoilage (proteolysis, lipolysis, etc.) have not been described in detail for cultured dairy products such as sour cream and yogurt. The objective of the present study was to test the ability of spore-forming strains isolated from dairy environments for their spoilage-causing activities at typical sour cream (24°C) and yogurt (42°C) fermentation temperatures. A total of 25 spore-forming strains were isolated from different sources, including raw milk, pasteurizer balance tank, biofilms formed on heat exchangers, and milk powder. These strains were tested for proteolytic and lipolytic activities and for their ability to degrade phospholipids, common stabilizers (starch, gelatin, xanthan gum, pectin), and exopolysaccharides (EPS) at sour cream and yogurt fermentation temperatures. A higher percentage of positive strains was observed for selected activities at yogurt fermentation temperature compared with sour cream fermentation temperature. Identified proteolytic spore-forming strains, based on a skim milk agar method, were subsequently quantified for their level of proteolysis using non-casein nitrogen (NCN) content and sodium dodecyl sulfate-PAGE (SDS-PAGE). The proteolytic strains that showed the highest levels of proteolysis (highest percentages of NCN content) at 24°C were Bacillus mojavensis BC, Bacillus cereus DBC, Bacillus subtilis DBC, B. mojavensis DBC1, and Paenibacillus polymyxa DBC1. At 42°C the strains with the highest levels of proteolysis (highest percentages of NCN content) were B. subtilis DBC, B. mojavensis BC, B. mojavensis DBC1, B. cereus DBC, and Bacillus licheniformis DBC6. Results of SDS-PAGE demonstrated that proteolytic strains had primarily hydrolyzed β- and κ-CN. A viscometric method was used to evaluate the susceptibility of exopolysaccharides (EPS) to degradation by selected spore formers. This method helped to determine that EPS produced by commercial yogurt and sour cream cultures is susceptible to degradation by spore formers present in dairy environments.

1 December 2019 in Journal of Dairy Science
Verified
Journal Article
Closed access
BSB. Sprick
B. Sprick
ZLZ. Linghu
Z. Linghu
JAJayendra Amamcharla
Jayendra Amamcharla
LML.E. Metzger
L.E. Metzger
JSJ.S. Smith
J.S. Smith
In recent years, using dairy phospholipids (PL) as functional ingredients has increased because PL have nutritional benefits and functional properties. In this study, a novel 2-step supercritical fluid extraction (SFE) process was used to extract whey protein phospholipid concentrate (WPPC), a dairy co-product obtained during the manufacture of whey protein isolate, for PL enrichment. In the first step, nonpolar lipids in WPPC were removed using neat supercritical carbon dioxide (S-CO2) at 41.4 MPa and 60°C. In the second stage, the feasibility of using the polar solvent ethanol as a co-solvent to increase the solubility of S-CO2 extraction solvent was explored. A 3 × 3 × 2 factorial design with extraction pressure (35.0, 41.4, and 55.0 MPa), temperature (40 and 60°C), and concentration of ethanol (10, 15, and 20%) as independent factors was used to evaluate the extraction efficiency providing the most total PL, and the best proportion of each individual PL from the spent solids collected during S-CO2 SFE. All lipid fractions were analyzed using thin-layer chromatography and high-performance lipid chromatography. The total amount of PL extracted from WPPC was significantly affected by ethanol concentration; the extraction pressure and temperature were nonsignificant. The optimal SFE condition for generating a concentrated PL lipid fraction was 35.0 MPa, 40°C, and 15% ethanol concentration; the highest amount of extracted PL averaged 26.26 g/100 g of fat. Moreover, adjusting SFE condition allowed successful recovery of a high concentration of sphingomyelin, phosphatidylcholine, and phosphatidylethanolamine, giving averages of 11.07, 10.07, and 7.2 g/100 g of fat, respectively, 2 to 3 times more than conventional solvent extraction. In addition, exhausted solids obtained after the SFE process were enriched with denatured proteins (72% on dry basis) with significantly more water-holding capacity and emulsifying capacity than untreated WPPC. Overall, this 2-stage SFE process using neat S-CO2 and ethanol has the greatest potential to produce a PL-rich lipid fraction from WPPC.