1 January 2015 in Procedia Engineering
Dynamic processes that occur on the coast and the development of coastal areas can cause problems in coastal areas such as erosion and sedimentation. To solve these issues, some types of coastal protection can be applied. On the other hand, to determine the right choice of protection, it must be known in advance whether the erosion or sedimentation would be issued. Incidence of erosion or sedimentation on the coast can be predicted by using the wave parameters for instance wave height and wave period. For the case of grain sediment, the parameters are performed such as diameter and settlement velocity of sediment grain. To predict the erosion and sedimentation, the Kraus's equation is used. It is predicted that erosion and coastal sedimentation in South Sulawesi shows the sedimentation occurs on the Pare-Pare Mattirotasi Beach with the small wave conditions (normal), while the big wave conditions at several points along the eroding shoreline. For the case of Tanjung Bayang, te erosion takes place either in small wave or big wave. On the other hand, the wave height in Tanjung Bira obtained from the wave forecasting results based on the wind data BMKG Selayar waters relatively large yield is 0.89∼1.64 m. So that the sediment grain size is relatively large will experience sedimentation and the smaller grains will easily carried away by the waves and currents that occur so easily eroded
20 February 2019 in IOP Conference Series: Earth and Environmental Science
1 January 2015 in Procedia Engineering
DSDadang Ahmad Suriamihardja
Dadang Ahmad Suriamihardja
Due to the increasing activities of underwater earthquake along the Sulawesi's Waters past this one last decade, the development of future tsunami mitigation plan become important for Sulawesi Island. This research pin pointed to the easiness of the mitigation plan concept and the availability of the infrastructure.The development of this mitigation plan was based on future tsunami modeling of Manakarra Beach of Mamuju at West Sulawesi Province. TUNAMI N2 algorithm at SiTProS Ver 1.5 was used on the tsunami propagation modeling and based on Sulawesi Seismic System for tsunami generation. Tsunami run-ups and time impact interval as the modeling results, were used as basis to develop the tsunami mitigation plan for the Manakarra Beach.The evacuation scheme which put into map and module for the Manakarra Beach of Mamuju has been established in this research; with mainly based on a mass evacuation plan to the high buildings or high ground
1 September 2026 in Civil Engineering Journal
This study aims to simulate tsunami wave propagation and estimate the spatial distribution of run-up and inundation generated by the 2005 Nias–Simeulue megathrust earthquake. The analysis was conducted using the COMCOT (Cornell Multi-grid Coupled Tsunami Model), integrating high-resolution bathymetric data from BATNAS and topographic data from DEMNAS. The earthquake source was parameterized with a moment magnitude (Mw) of 8.6, a rupture length of approximately 300 km, and an average vertical slip of 4.5 m. The simulation results reveal that the maximum sea surface elevation exceeded 5 m near the source region, particularly southwest of Nias Island. Tsunami waves propagated radially with amplitudes strongly controlled by seabed configuration and coastal morphology. Wave heights reached approximately 5.6 m in Nias and 4.7 m in Simeulue, with inundation distances extending 200–250 m inland. Tide gauge analysis indicates that the first wave arrived within 10 minutes of the earthquake, followed by multiple significant waves. The novelty of this study lies in the integration of high-resolution national datasets with COMCOT to enhance the accuracy of tsunami hazard estimation, providing improved predictive capability for coastal risk assessment and supporting more effective mitigation and early warning strategies in tsunami-prone regions.
1 November 2019 in IOP Conference Series: Materials Science and Engineering
Breakwater is a structure that builds parallel to the coast, and located within some distance from the coastline. The breakwater that is currently and widely used is Rubble Mound Breakwater; a large dimension coastal structure with also come in high price. Due to this matter, a Hanging Sheet Pile type breakwater can be one of good solution. This research was conducted at Ocean Technology Laboratory, Faculty of Engineering, Universitas Hasanuddin, in a flume thank with 1:25 model scale, and equipped with wave generator and probes as measurement apparatus. The purpose of this study is to identify the effect of wave parameters (Hi/gT2) and structure parameters (draft relative, s/d) on fluctuated wave transmission coefficients produced. The waves are in the form of irregular waves that generated using JONSWAP spectrum. There were 5 variations in wave height (H) and wave period (T), while variations of structure in the form of draft (s) are in 3 variations. The results of this study indicate that the value of Kt will decrease when Hi/gT2 value increase; so that the greater the value of s/d, the smaller value of Kt will be.