24 December 2019 in Hydrogeology Journal
16 September 2015 in IEEE Journal of Selected Topics in Quantum Electronics
Yb-doped double-cladding photonic crystal fibers are one of the key enabling factors for the development of high-power fiber lasers, due to their capability to provide a very large-mode-area together with the effective suppression of high-order modes, while allowing strong pump absorption and efficient conversion. Thermal effects are currently considered as the main bottleneck for future power scaling; since beyond a certain average power, they allow guidance of high order modes and energy transfer to them, causing a sudden degradation of the beam quality. In this paper, the effects of the heat load on the modes of double cladding fibers are thoroughly analyzed with a full-vector modal solver based on the finite-element method with integrated steady-state heat equation solver. Fibers with different inner cladding designs are compared to provide a deeper understanding of the mechanisms beyond the mode reconfinement and coupling. The influence of the fiber design on the robustness of the single-mode regime with respect to fiber heating has been demonstrated, providing a clear picture of the complex interaction between modes. On the basis of simulation results it has been possible to group fiber modes into three families characterized by peculiar reaction to heating.
23 October 2009 in Applied Optics
A new fabrication process of active optical silica glass based on direct sand vitrification is proposed. This method, an alternative to chemical vapor deposition (CVD), allows the fabrication of homogeneous and highly -doped rods that are ten times larger in diameter than those produced by CVD. For large-mode-area fibers fabricated by the stack-and-draw method, this is a tremendous technical breakthrough that could offer great flexibility in fiber design. As a proof of concept, we focused here on the fabrication and characterization of active core material surrounded by pure silica. Consequently, we draw a simple multimode step-index fiber. The index ripple in the core that matches our objectives is approximately . For this first demonstration, the core material is codoped with ( by weight) and , yielding a absorption at a wavelength of , whereas the background loss is around . The continuous-wave laser obtained with this fiber exhibits 74% slope efficiency.
12 September 2014 in Physical Chemistry Chemical Physics
The vibrational properties (anharmonicity, vibrational relaxation lifetime…) of water in crowded myoglobin solutions remain the same as that in neat water but the collective properties of the water molecules are significantly affected by the protein (orientational time, solid–liquid transition).
26 January 2024 in Astronomy & Astrophysics
We report new optical constants (refractive index, n, and extinction coefficient, k) for exoplanet haze analogs from 0.3 to 30 µm. The samples were produced in a simulated N2-dominated atmosphere with two different abundance ratios of CO2 and CH4, using the PAMPRE plasma reactor at LATMOS. We find that our haze analogs present a significantly lower extinction coefficient in the optical and near-infrared (NIR) range compared to the seminal data obtained on Titan haze analogs. We confirm the stronger IR absorption expected for hazes produced in a gas mixture with higher CO2 abundances. Given the strong impact of the atmospheric composition on the absorbing power of hazes, these new data should be used to characterize early-Earth and CO2-rich exoplanet atmospheres. The data presented in this paper can be found in the Optical Constants Database. Using ellipsometry or spectrophotometry, the retrieved optical constants are affected by the sensitivity of the measurement and the accuracy of the calculations. A comparative study of both techniques was performed to identify limitations and better understand the discrepancies present in the previous data. For the refractive index n, errors of 1–3% are observed with both optical techniques and the different models, caused by the correlation with the film thickness. We find that UV-visible reflection ellipsometry provides similar n values, regardless of the model used; whereas the Swanepoel method on transmission is more subjected to errors in the UV. In the UV and mid-infrared (MIR), the different calculations lead to rather small errors on k. Larger errors of k arise in the region of weak absorption, where calculations are more sensitive to errors on the refractive index n.