It is essential for mankind to address greenhouse gas emission, depletion of fossil resources and development of efficient storage and transportation of renewable energy. By using the atmospheric gas CO2 as raw material for the value-added chain, an overall CO2 neutral circular economy is imaginable. The power to gas (PtG) concept tackles all three topics by producing methane as energy carrier using renewable hydrogen and capture of CO2. Methanation has been known for decades; however, the preparation of noble metal free catalysts possessing high activity, selectivity and stability remains challenging. Bimetallic FexNix−1 alloy catalysts have shown synergistic effects for methanation as they can be tailored to the CO dissociation energy. Multicomponent hydrotalcite precursors allow close proximity of the individual metals enabling high dispersion and continuous variation of the composition. Herein, we studied Ni–Fe/(Mg, Al)Ox bimetallic catalysts derived via mixed hydrotalcite precursors. Iron has a significant influence on both activity and selectivity due to small particle sizes, facilitated CO dissociation, and tailored surface basicity. For the best catalyst (Fe/Ni = 0.1), the CO2 conversion rate reaches about 6.96 mmol CO2 molFe+Ni−1 s−1 at 335 °C with a selectivity of 99.3% to CH4, remaining constant for at least 24 h time on stream.
Ni–Fe/AlOx with nanosheet structure, enhance the reducibility and stability of the Ni-hydroxide during the catalytic reaction due to the formation of spinel phase which stabilize smaller Ni nanoparticle with a weaker interaction with the support.
Methanation of residual syngas as a downstream process after liquefied petroleum gas (LPG) synthesis is considered to be an attractive alternative to conventional gas separation. Seven intensively studied factors in catalyst development (ratio of Fe/Ni, metal loading, selection of Al2O3 or SiO2 as oxidic support, addition of promoters such as potassium and/or MgO, heat dissipation by diluting with inert material and two common preparation techniques (impregnation and precipitation)) were selected within a Plackett–Burman screening design and rated towards their impact on catalytic performance such as carbon monoxide and hydrocarbon conversion as well as methane and carbon dioxide selectivity. Detailed characterization of fresh and used catalysts has been carried out applying N2-physisorption, X-ray diffraction (XRD), inductively coupled plasma atomic emission spectroscopy (ICP-AES), temperature-programmed reduction (H2-TPR), and transmission electron microscopy with energy-dispersive spectroscopy (TEM/EDS) in order to confirm the results. Finally, suggestions on the preferred levels of these factors are made for development of advanced catalysts.