Brighter perovskite LEDs: Organic-inorganic hybrid perovskites such as methyl ammonium lead halides are attractive as low-cost light-emitting diode (LED) emitters. This is because, unlike many inorganic nanomaterials, they have very high color purity. Cho et al. made two modifications to address the main drawback of these materials, their low luminescent efficiency. They created nanograin materials lacking free metallic lead, which helped to confine excitons and avoid their quenching. The perovskite LEDs had a current efficiency similar to that of phosphorescent organic LEDs. Science , this issue p. 1222
Already exhibiting solar to electrical power conversion efficiencies of over 17%, organic–inorganic lead halide perovskite solar cells are one of the most promising emerging contenders in the drive to provide a cheap and clean source of energy. One concern however, is the potential toxicology issue of lead, a key component in the archetypical material. The most likely substitute is tin, which like lead, is also a group 14 metal. While organic–inorganic tin halide perovskites have shown good semiconducting behaviour, the instability of tin in its 2+ oxidation state has thus far proved to be an overwhelming challenge. Here, we report the first completely lead-free, CH3NH3SnI3 perovskite solar cell processed on a mesoporous TiO2 scaffold, reaching efficiencies of over 6% under 1 sun illumination. Remarkably, we achieve open circuit voltages over 0.88 V from a material which has a 1.23 eV band gap.
Perovskite layers make the grade: Inverted planar perovskite solar cells offer opportunities for a simplified device structure compared with conventional mesoporous titanium oxide interlayers. However, their lower open-circuit voltages result in lower power conversion efficiencies. Using mixed-cation lead mixed-halide perovskite and a solution-processed secondary growth method, Luo et al. created a surface region in the perovskite film that inhibited nonradiative charge-carrier recombination. This kind of solar cell had comparable performance to that of conventional cells. Science , this issue p. 1442
To date, there have been a plethora of reports on different means to fabricate organic–inorganic metal halide perovskite thin films; however, the inorganic starting materials have been limited to halide-based anions. Here we study the role of the anions in the perovskite solution and their influence upon perovskite crystal growth, film formation and device performance. We find that by using a non-halide lead source (lead acetate) instead of lead chloride or iodide, the perovskite crystal growth is much faster, which allows us to obtain ultrasmooth and almost pinhole-free perovskite films by a simple one-step solution coating with only a few minutes annealing. This synthesis leads to improved device performance in planar heterojunction architectures and answers a critical question as to the role of the anion and excess organic component during crystallization. Our work paves the way to tune the crystal growth kinetics by simple chemistry.