8 April 2016 in Journal of Engineering Education
1 January 2015 in Journal of Experimental Biology
Locomotion imposes some of the highest loads upon the skeleton, and diverse bone designs have evolved to withstand these demands. Excessive loads can fatally injure organisms; however, bones have a margin of extra protection, called a ‘safety factor’ (SF), to accommodate loads that are higher than normal. The extent to which SFs might vary amongst an animal's limb bones is unclear. If the limbs are likened to a chain composed of bones as ‘links’, then similar SFs might be expected for all limb bones because failure of the system would be determined by the weakest link, and extra protection in other links could waste energetic resources. However, Alexander proposed that a ‘mixed-chain’ of SFs might be found amongst bones if: 1) their energetic costs differ, 2) some elements face variable demands, or 3) SFs are generally high. To test if such conditions contribute to diversity in limb bone SFs, we compared the biomechanical properties and locomotor loading of the humerus and femur in the tiger salamander (Ambystoma tigrinum). Despite high SFs in salamanders and similar sizes of the humerus and femur that would suggest similar energetic costs, the humerus had lower yield stresses, higher mechanical hardness, and larger SFs. SFs were greatest in the anatomical regions where yield stresses were highest in the humerus and lowest in the femur. Such intraspecific variation between and within bones may relate to their different biomechanical functions, providing insight into the emergence of novel locomotor capabilities during the invasion of land by tetrapods
13 January 2016 in Metallurgical and Materials Transactions A
3 July 2012 in Journal of Materials Science
22 October 2016 in Journal of Renewable Materials
CKChristopher L. Kitchens
Spin coating was used to cast a uniform film of cellulose nanocrystals with low surface roughness and variable thickness as a function of operational parameters that include rotational speed and dispense suspension concentration. The film thickness was controllable from 40 nm up to 1 μm with surface roughness an order of magnitude less than blade-coating methods. The degree of radial orientation was qualitatively assessed and shown to be variable with processing parameters. Under specific processing conditions, the formation of striation patterns was observed and associated with film drying instability. The striation patterns are periodic in nature where the wavelength and amplitude are controllable to a certain degree with wetting film concentration and rotational speed. The striation patterns possess ordered, oriented nanorods, which exist as both rippled ring-like structures and radial ridges along the shear direction. There is potential to employ these rippled structures as low-cost manufacturing of ordered materials, device platforms, or optical components such as diffraction gratings. Mechanical properties of the films were measured by nanoindentation. The maximum elastic modulus of the films was 8.3 GPa and the maximum hardness was 322 MPa. A post-drying heat treatment (80 °C) was employed and resulted in a 17% increase in modulus and 35% increase in hardness, which is attributed to the formation of an enhanced intermolecular hydrogen bonding network between nanocrystals with removal of bound water.
1 November 2015 in Materials Science and Engineering: A