Combustion of solid combustible wastes is the most common way of their disposal. In developed European countries, up to 50% of all municipal waste is burned; in Russia, it is estimated to be less than 2.5%. The efficiency of modern thermal plants operating on MSW and biomass, as well as the capacity of individual combustion units are continuously increasing, approaching the average values that are close to fossil fuels plants. Replacing coal with combustible waste will make it possible to reduce the cost of energy production and reduce the load on waste landfills. However, to this end, it is necessary to solve the problems of organizing efficient combustion as well as cleaning of combustion products. Of particular interest is the co-processing of municipal waste along with lignocellulosic waste from agriculture and the forest industry. In the present work, the thermal behavior of woody biomass and polyethylene mixtures (in different mass ratios) when heated in an oxidizing environment is investigated using methods of thermal analysis. The distribution of the products of pyrolysis and oxidation is investigated by means of mass spectrometry.
1 June 2019 in Journal of Physics: Conference Series
There are many methods for obtaining kinetic data of thermochemical conversion of fuel particles. These methods to some extent reproduce the conditions of industrial processes. At the same time, there is a lack of methods reproducing the conditions of wood particles gasification in downdraft gasifier. In this process, raw fuel enters the hot reactor region with intense air jets blowing through the tuyeres. It is difficult to directly measure the weight of particles under these conditions due to the effect of gas flow. The authors proposed a research method in accordance with which the sample is introduced into a heated furnace and placed in the tuyere flow. The sample is combusted for a certain time then removed from the furnace and quickly quenched. The method allows reproducing the dynamics of changes in temperature, mass, volume, shape and structure of the inner layers of particles. It provides visual observations of the process, high heating rate of wood samples (750-5500 °C min−1) and large amount of data sufficient for statistical processing.
In this work, it is proposed to represent systems that are heterogeneous in terms of intensive parameters as a set of homogeneous subsystems between which extensive parameters are transferred. With this approach, it is possible to simplify the system by combining subsystems (or already the vertices of a graph) without losing its physical sense. This technique has been applied to simulate a lead acid battery.
This paper presents materials for modeling heat transfer in a lead-acid battery in its operating mode. The approach for modeling was based on the representation of the system under study in the form of a flow graph. This approach made it possible to create a model of a battery taking into account the chemical and physical aspects of its operation and can be supplemented with other properties of the system under study, if necessary. Calculations of the temperature dependence were carried out for a daily load and in charge and discharge modes.
1 January 2022 in Информационные и математические технологии в науке и управлении
This article proposes a method for processing data obtained using the TA-MS complex. To search for calibration coefficients, the method includes solving a quadratic programming problem. To test the method of searching for calibration coefficients, a simulation was done and the inverse problem was solved, and it was found out that the problem was ill-conditioned.