4 January 2023 in IEEE Access
Growing energy consumption is a global problem. The information and communications technology (ICT) industry is in a critical role as an enabler of energy savings in other sectors. However, the power consumption of the ICT sector also needs to be addressed, to contribute to the overall reduction of power consumption and carbon emissions. A new era has begun as the fifth generation (5G) mobile data connection rollouts are advancing globally and are expected to reach a 10% share of end-user devices and connections by 2023. The available references on energy consumption in global mobile networks are rather old and highly averaged – only estimates of energy consumption relative to data volumes are available. There is an information gap regarding the energy consumption of emerging 5G and advanced 4G technologies. Therefore, it has been difficult to understand the actual electricity consumption differences between generations and spatially aggregated electricity consumption once these generations are combined to offer capacity and coverage. This article fills this gap by providing a reference on the energy consumption of base transceiver stations for reported mobile data usage for different Radio Access Technologies; 3G, 4G and 5G respectively. To the best of our knowledge, there is no reference to scientific research on the comparison of energy intensity per square kilometer for 3G, 4G and 5G mobile radio technologies, using actual operator data. The objective of this research was to improve the understanding of the actual energy consumption of different Radio Access Technologies (RAT). The results also give insight to decision makers on when to modernize the operator radio access network. The article reports on the results of field measurements on data and visitor volumes and shares of different RATs. The research contains two statistical RAT combination cases, one representing the European average and the other Finnish mobile networks. The analyses were done for dense urban (DU) and suburban (SU) areas.
12 October 2006 in Quality and Reliability Engineering International
27 May 2014 in Soldering & Surface Mount Technology
Purpose: – The purpose of this paper is to describe the behavior of different lead-free solders (95.5Sn3.8Ag0.7Cu, i.e. SAC387 and Sn7In4.1Ag0.5Cu, i.e. SAC-In) in thermomechanically loaded non-collapsible ball grid array (BGA) joints of a low-temperature co-fired ceramic (LTCC) module. The validity of a modified Engelmaier’s model was tested to verify its capability to predict the characteristic lifetime of an LTCC module assembly implementable in field applications. Design/methodology/approach: – Five printed wiring board (PWB) assemblies, each carrying eight LTCC modules, were fabricated and exposed to a temperature cycling test over a −40 to 125°C temperature range to determine the characteristic lifetimes of interconnections in the LTCC module/PWB assemblies. The failure mechanisms of the test assemblies were verified using scanning acoustic microscopy, scanning electron microscopy (SEM) and field emission SEM investigation. A stress-dependent Engelmaier’s model, adjusted for plastic-core solder ball (PCSB) BGA structures, was used to predict the characteristic lifetimes of the assemblies. Findings: – Depending on the joint configuration, characteristic lifetimes of up to 1,920 cycles were achieved in the thermal cycling testing. The results showed that intergranular (creep) failures occurred primarily only in the joints containing Sn7In4.1Ag0.5Cu solder. Other primary failure mechanisms (mixed transgranular/intergranular, separation of the intermetallic compound/solder interface and cracking in the interface between the ceramic and metallization) were observed in the other joint configurations. The modified Engelmaier’s model was found to predict the lifetime of interconnections with good accuracy. The results confirmed the superiority of SAC-In solder over SAC in terms of reliability, and also proved that an air cavity structure of the module, which enhances its radio frequency (RF) performance, did not degrade the reliability of the second-level interconnections of the test assemblies. Originality/value: – This paper shows the superiority of SAC-In solder over SAC387 solder in terms of reliability and verifies the applicability of the modified Engelmaier’s model as an accurate lifetime prediction method for PCSB BGA structures for the presented LTCC packages for RF/microwave telecommunication applications.