1 February 2019 in Review of Scientific Instruments
We present a design for a piezoelectric-driven uniaxial stress cell suitable for use at ambient and cryogenic temperatures and that incorporates both a displacement and a force sensor. The cell has a diameter of 46 mm and a height of 13 mm. It can apply a zero-load displacement of up to ∼45 μm and a zero-displacement force of up to ∼245 N. With combined knowledge of the displacement and force applied to the sample, it can quickly be determined whether the sample and its mounts remain within their elastic limits. In tests on the oxide metal Sr2RuO4, we found that at room temperature serious plastic deformation of the sample onset at a uniaxial stress of ∼0.2 GPa, while at 5 K the sample deformation remained elastic up to almost 2 GPa. This result highlights the usefulness of in situ tuning, in which the force can be applied after cooling samples to cryogenic temperatures.
25 August 2016 in Nature Communications
Among the frustrated magnetic materials, spin-ice stands out as a particularly interesting system. Residual entropy, freezing and glassiness, Kasteleyn transitions and fractionalization of excitations in three dimensions all stem from a simple classical Hamiltonian. But is the usual spin-ice Hamiltonian a correct description of the experimental systems? Here we address this issue by measuring magnetic susceptibility in the two most studied spin-ice compounds, Dy2Ti2O7 and Ho2Ti2O7, using a vector magnet. Using these results, and guided by a theoretical analysis of possible distortions to the pyrochlore lattice, we construct an effective Hamiltonian and explore it using Monte Carlo simulations. We show how this Hamiltonian reproduces the experimental results, including the formation of a phase of intermediate polarization, and gives important information about the possible ground state of real spin-ice systems. Our work suggests an unusual situation in which distortions might contribute to the preservation rather than relief of the effects of frustration.
1 August 2020 in Review of Scientific Instruments
Response to uniaxial stress has become a major probe of electronic materials. Tunable uniaxial stress may be applied using piezoelectric actuators, and so far two methods have been developed to couple samples to actuators. In one, actuators apply force along the length of a free, beam-like sample, allowing very large strains to be achieved. In the other, samples are affixed directly to piezoelectric actuators, allowing the study of mechanically delicate materials. Here, we describe an approach that merges the two: thin samples are affixed to a substrate, which is then pressurized uniaxially using piezoelectric actuators. Using this approach, we demonstrate the application of large elastic strains to mechanically delicate samples: the van der Waals-bonded material FeSe and a sample of CeAuSb2 that was shaped with a focused ion beam.
15 May 2021 in Journal of the Physical Society of Japan
Ambipolar transport is a commonly occurring theme in semimetals and semiconductors. Here we present an analytical formulation of the conductivity for a two-band system. Electron and hole carrier de...
1 December 2022 in New Journal of Physics
The discovery of superconductivity in the quantum critical Kondo-lattice system YbRh2Si2 at an extremely low temperature of 2 mK has inspired efforts to perform high-resolution electrical resistivity measurements down to this temperature range in highly conductive materials. Here we show that control over the sample geometry by microstructuring using focused-ion-beam techniques allows to reach ultra-low temperatures and increase signal-to-noise ratios (SNRs) tenfold, without adverse effects to sample quality. In five experiments we show four-terminal sensing resistance and magnetoresistance measurements which exhibit sharp phase transitions at the Néel temperature, and Shubnikov–de-Haas (SdH) oscillations between 13 T and 18 T where we identified a new SdH frequency of 0.39 kT. The increased SNR allowed resistance fluctuation (noise) spectroscopy that would not be possible for bulk crystals, and confirmed intrinsic -type fluctuations. Under controlled strain, two thin microstructured samples exhibited a large increase of from 67 mK up to 188 mK while still showing clear signatures of the phase transition and SdH oscillations. Superconducting quantum interference device-based thermal noise spectroscopy measurements in a nuclear demagnetization refrigerator down to 0.95 mK, show a sharp superconducting transition at mK. These experiments demonstrate microstructuring as a powerful tool to investigate the resistance and the noise spectrum of highly conductive correlated metals over wide temperature ranges.
3 April 2026 in Nature Physics
Topological superconductors, characterized by spin-triplet Cooper pairing, are important for exploring unconventional pairing mechanisms and protected quantum states. Yet experimentally established odd-parity, spin-triplet superconductors remain scarce. Here we demonstrate that the heavy-fermion compound YbRh 2 Si 2 hosts distinct magnetic-field-tuned superconducting states, both Pauli limited and beyond this limit, revealed by high-resolution measurements of the complex electrical impedance. We also find that superconductivity is abruptly suppressed at the critical field associated with the primary antiferromagnetic transition of this compound. The onset of electro-nuclear spin density wave order enhances the superconductivity. We propose that this behaviour can be explained by the formation of a pair density wave that boosts a selected spin-triplet superconducting order parameter. Together, our findings indicate odd-parity superconductivity in YbRh 2 Si 2 and point to one of the superconducting states being the topological helical phase.