26 February 2025 in IEEE Transactions on Instrumentation and Measurement
Three-axis magnetometers (TAMs) provide rich measurement information and are widely used in magnetic target detection, geological measurement, geomagnetic navigation, and other fields. The interference from the TAM itself and carriers significantly affect TAM measurement and detection performance, thus need to be compensated before use. Insufficient data often leads to compensation failure. How to evaluate the relationship between effective data volume and compensation performance has not been solved yet. To address this issue, we propose a compensation data evaluation method. By constructing a data matrix related to compensation data, the distribution of the matrix rank is analyzed to determine the number of valid singular values that can be used for compensation. The results indicate that when the TAM rotates around a single axis, two axes and three axes during compensation, the number of valid singular values is five, eight and nine respectively. When the TAM rotates freely during compensation, the number of valid singular values is related to the inflection point of the singular value distribution. When the number of valid singular values is applied to interference compensation and target detection, good results were achieved. Before compensation, the magnetic noise (peak-to-peak) caused by the TAM rotating with the seawater is 235.2 nT, and the target signal is submerged in the noise and cannot be detected. When the rank of 9 is used for compensation, the compensated value deviates from the true value and cannot be used for detection. When the rank of 8 is used, the noise after compensation is 8.6 nT (peak-to-peak), and the magnetic anomaly target can be easily detected, which is 21.6 nT (peak-to-peak).
29 July 2025 in IEEE Transactions on Instrumentation and Measurement
Three-axis magnetometers (TAMs) are widely employed in a variety of applications,including geological surveys, navigation, and military fields. The interference introduced by the TAM itself and the mounted carrier significantly constrain the effectiveness of these measurements and the ability for magnetic anomaly detection (MAD), especially when the TAM is under shaking movements. Implementing compensation strategies by exploiting the geomagnetic field can reduce the interference. However, the geomagnetic field often encompasses time-varying magnetic noise with the progression of industrialization, which frequently leads to the failure of the TAM compensation. To address this critical challenge, we propose a compensation method that accounts for time-varying magnetic noise. The method first employs an uncompensated TAM to adaptively learn the time-varying magnetic noise, then applies the learned parameters directly within the TAM compensation model. Finally, we significantly reduce the impact of time-varying noise during the TAM compensation. After compensation, the TAM scalar output noise reduced a lot and the ability for MAD improved a lot. The experimental results demonstrate that for a MAD test during shaking movement, the peak-to-peak noise was 135.4 nT without any compensation, which was reduced to 36.9 nT by using the nonlinear least square-based calibration method, 31.2 nT by using the particle swarm optimization-based calibration method, and 5.6 nT by using the calibration method proposed in this study. Notably, the magnetic field of the target was 11.7 nT when the it passed by. In this case, only the compensation method proposed in this paper was able to effectively distinguish the target magnetic anomaly signal.