11 November 2025 in Ocean Engineering
1 October 2025 in Physics of Fluids
Wake-added turbulence (WAT) is a critical component of wake effects in floating wind farms. Although previous studies have shown that wakes reduce the inflow wind speed and increase turbulence intensity for wake-affected floating offshore wind turbines (FOWTs), the specific impacts of wake effects and WAT on FOWTs under identical mean inflow wind speed conditions remain insufficiently quantified. To address this gap, an unwaked FOWT with the same average inflow wind speed as the wake-affected FOWT is established to enable comparative analysis of the dynamic responses, thereby investigating the influence of wake effects on FOWTs. WAT is further incorporated to assess its impact on the dynamic responses of wake-affected FOWTs. The average conditional exceedance rate method is employed to estimate short-term extreme loads, and short-term damage equivalent loads are calculated at critical structural locations. Results show that, compared to the unwaked FOWT, the surge motion and structural load amplitudes of the wake-affected FOWT exhibits up to 42% and 28%, respectively. Neglecting wake effects can lead to an underestimation of short-term extreme loads by approximately 10%. Under below-rated wind speed, WAT intensifies wake effects, increasing structural load amplitudes by about 7%, and causing fatigue loads to be underestimated by up to 8% if WAT is not considered. This study quantitatively analyzes wake effects and WAT on FOWT responses, offering insights for structural design verification and fatigue life prediction of FOWTs, and contributing to the refinement of wake modeling in international design standards.
11 February 2026 in Applied Ocean Research
1 April 2026 in Physics of Fluids
Deep-sea mining disturbs benthic sediments, generating plumes that can mobilize heavy metal ions and pose ecotoxicological risks to marine ecosystems. Understanding the associated wake and plume dynamics is therefore crucial for environmental impact assessment. This study develops a novel particle–turbulence interacting Eulerian (PT–Euler) model, which modifies governing-equation source terms to resolve PT interactions. Model validation shows less than 5% deviation in key concentration fields and good agreement in plume morphology with experimental data. Simulations investigate the trailing plume dispersion from a mining vehicle, focusing on the dimensionless vehicle speed (Vn: the ratio of vehicle movement speed to sediment discharge speed; Vn = 0–2) and initial sediment concentration (αs = 0.009–0.030). Results show that both factors significantly affect dispersion, with speed dominating the pattern and concentration exerting a secondary modulation. Higher speed promotes plume rise and horizontal spread, while increased sediment concentration suppresses these trends. Vehicle motion induces near-field uplift through entrainment and enhances far-field advective transport via the wake. Flow separation and wake recirculation generate strong vortices that amplify ascent; at higher speeds, vortex-induced confinement in the near-field transitions to a pronounced downstream “transport effect” in the far-field. These findings provide critical insights for evaluating and mitigating the environmental impacts of deep-sea mining operations.
1 June 2026 in Journal of Energy Engineering
1 March 2026 in Physics of Fluids
Coandă-effect-based nodule collectors generate vertical pressure gradient through a convex curved-wall structure to enable the detachment and collection of nodule particles, which demonstrates considerable potential for engineering applications. The Large Eddy Simulation (LES) method was verified and employed to conduct a comprehensive numerical investigation on the flow field generated by this kind of collector under different bottom clearances h, jet velocities v, and moving speeds V. The results indicate that a high-velocity and low-pressure zone forms within the narrow region near the curved-wall, accompanied by the presence of numerous vortex structures in the vicinity of the seabed and the rear wall. The disturbance zone exhibits a distinct triangular morphology in planform. Along the streamwise direction, the extremum of the vertical pressure difference |ΔPz0|max under different v consistently occurs near x/h = 0.5, while the effective high-pressure zone is vertically confined to the region where z/h > −0.19. It is recommended that the operational h be matched to the specific working conditions. The influence of h on |ΔPz0|max exhibits an oscillatory behavior, while the effects of v and V follow well-defined quadratic and cubic relationships, respectively. These findings reveal the flow field characteristics of Coandă-effect-based collectors and provide practical guidance for the selection of operational parameters in deep-sea nodule collecting.