Matthew B. Lim

Matthew B. Lim

Auto-generated profile, based on publicly available information

Matthew B. Lim

Department of Materials Science and Engineering, University of Washington, Seattle, Washington 98195, United States

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 January 2021 in Materials Science and Engineering: R: Reports
Verified
Journal Article
Closed access
MLMatthew B. Lim
Matthew B. Lim
TLTimothy Lambert
Timothy Lambert
BCBabu R. Chalamala
Babu R. Chalamala

3 May 2019 in Science Advances
Verified
Journal Article
Open access
PDF file
MCM. J. Crane
M. J. Crane
APAlessio Petrone
Alessio Petrone
RBR. A. Beck
R. A. Beck
MLM. B. Lim
M. B. Lim
XZXuezhe Zhou
Xuezhe Zhou
PPPeter J Pauzauskie
Peter J Pauzauskie
We create defects for quantum technologies by using high temperatures and pressures to convert molecularly doped carbon to diamond.

4 January 2020 in Journal of the Electrochemical Society
Verified
Journal Article
Open access
PDF file
MLMatthew B. Lim
Matthew B. Lim
TLTimothy Lambert
Timothy Lambert
ERElijah I. Ruiz
Elijah I. Ruiz
Rechargeable alkaline batteries containing zinc anodes suffer from redistribution of active material due to the high solubility of ZnO in the electrolyte, limiting achievable capacity and lifetime. Here, we investigate pre-saturating the KOH electrolyte with ZnO as a strategy to mitigate this issue, utilizing rechargeable Ni–Zn cells. In contrast to previous reports featuring this approach, we use more practical limited-electrolyte cells and systematically study ZnO saturation at different levels of zinc depth-of-discharge (DODZn), where the pre-dissolved ZnO is included in the total system capacity. Starting with 32 wt. % KOH, cells tested at 14%, 21%, and 35% DODZn with ZnO-saturated electrolyte exhibit 191%, 235%, and 110% longer cycle life respectively over identically tested cells with ZnO-free electrolyte, with similar energy efficiency and no voltage-related energy losses. Furthermore, anodes cycled in ZnO-saturated electrolyte develop more favorable compact zinc deposits with less overall mass loss. The effect of initial KOH concentration was also studied, with ZnO saturation enhancing cycle life for 32 wt % and 45 wt % KOH but not for 25 wt % KOH, likely due to cell failure by passivation rather than shorting. The simplicity of ZnO addition and its beneficial effect at high zinc utilization make it a promising means to make secondary alkaline zinc batteries more commercially viable.

26 February 2020 in Chemistry of Materials
Verified
Journal Article
Closed access
ABAlexander B. Bard
Alexander B. Bard
XZXuezhe Zhou
Xuezhe Zhou
XXXiaojing Xia
Xiaojing Xia
GZGuomin Zhu
Guomin Zhu
MLMatthew B. Lim
Matthew B. Lim
PPPeter J Pauzauskie
Peter J Pauzauskie

12 March 2018 in Journal of Materials Chemistry A
Verified
Journal Article
Closed access
PDF file
MLMatthew B. Lim
Matthew B. Lim
JHJennifer L. Hanson
Jennifer L. Hanson
LVLeron Vandsburger
Leron Vandsburger
PRPaden B. Roder
Paden B. Roder
XZXuezhe Zhou
Xuezhe Zhou
PPPeter J Pauzauskie
Peter J Pauzauskie
We present a scalable hydrothermal synthesis of one-dimensional palladium nanostructures from palladium(II) chloride precursor, mediated by the introduction of low concentrations of copper(II) ions and/or sodium chloride. Adding Cu at a molar ratio of ∼1 : 12 500 relative to Pd increases the yield of 1D nanostructures from 10% to 90%. Furthermore, NaCl enhances 1D nanostructure growth such that high yields of long Pd nanowires (PdNWs)—featuring the highest aspect ratios yet reported for solution-grown Pd nanocrystals, with diameters of 20 nm and lengths up to 7 μm—can be achieved in a third of the time required for the synthesis with Cu alone. X-ray diffraction, electron microscopy, and X-ray photoelectron spectroscopy measurements confirm that the as-synthesized nanowires are indeed metallic crystalline Pd with a 5-fold twinned cross-section. It is hypothesized that the Cu ions scavenge oxygen to suppress etching of the twinned Pd seeds that eventually grow into elongated structures, whereas NaCl improves the solubility of PdCl2 and lowers the reduction rate via formation of the PdCl4 2− complex, promoting diffusional growth. The high aspect ratio of the PdNWs facilitates their manipulation in an optoelectronic tweezers (OET) device, which we demonstrate as a way to enhance their applicability for catalysis and hydrogen sensing.

16 July 2018 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
MLMatthew B. Lim
Matthew B. Lim
RFRobert G. Felsted
Robert G. Felsted
XZXuezhe Zhou
Xuezhe Zhou
BSBennett E. Smith
Bennett E. Smith
PPPeter J. Pauzauskie
Peter J. Pauzauskie
Optoelectronic tweezers (OET) offer a means for parallel trapping and dynamic manipulation of micro-scale particles using low-intensity light. Such capabilities can facilitate the formation of bulk materials with a precisely tailored microstructure. Here, we report the use of OET to vertically align, trap, and reposition sheets of graphene oxide (GO) in liquids, paving the way for textured and patterned graphene macroassemblies that could offer superior performance for applications in energy storage, catalysis, and electronic devices. Trapping can be achieved with low-power light from inexpensive digital projectors and diode lasers, making it simple for users to create and apply patterns while avoiding undesirable photothermal heating effects. To give users a quantitative idea of trap stiffness, we also present a theoretical framework for predicting the maximum achievable speed of a GO platelet in an OET trap.