Estibaliz Apiñaniz

Estibaliz Apiñaniz

Auto-generated profile, based on publicly available information

Estibaliz Apiñaniz

Basque Country University (UPV/EHU)

Research Focus & Metrics

Academic Career Length

26Years (2001-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 July 2009 in Review of Scientific Instruments
Verified
Journal Article
Closed access
AMArantza Mendioroz
Arantza Mendioroz
RFRaquel Fuente
Raquel Fuente
EAEstibaliz Apiñaniz
Estibaliz Apiñaniz
ASAgustin Salazar
Agustin Salazar
Photothermal radiometry has been widely used to measure the thermal diffusivity of bulk materials. In the case of thin plates and filaments, a one-dimensional heat propagation model including heat losses has been developed, predicting that the thermal diffusivity can be obtained by recording both the surface temperature amplitude and phase profile slopes (“slope method”). However, this method has given highly overestimated values of the thermal diffusivity of poor-conducting films and filaments. In this paper we analyze the effect of the experimental factors affecting the thermal diffusivity measurements of thin plates and filaments using infrared thermography, in order to establish the experimental conditions needed to obtain accurate and reliable values of the diffusivity of any kind of material using the slope method. We present the calculations of the surface temperature of thin isotropic and anisotropic plates heated by a modulated and tightly focused laser beam, showing that the slope method is also valid for this kind of pointlike heating. Special attention is paid to the effect of surface heat losses (convective and radiative) on the diffusivity measurements of small-dimension and poor-conducting materials. Lock-in thermography measurements performed in the best experimental conditions on a wide set of samples of different thermal properties (thin isotropic and anisotropic plates and filaments) confirm the validity of the slope method to measure accurately the thermal diffusivity of samples of these shapes.

17 February 2014 in Measurement Science and Technology
Verified
Journal Article
Closed access
ASAgustin Salazar
Agustin Salazar
AMArantza Mendioroz
Arantza Mendioroz
EAEstibaliz Apiñaniz
Estibaliz Apiñaniz
CPChristophe Pradère
Christophe Pradère
FNFrédéric Noël
Frédéric Noël
JBJean-Christophe Batsale
Jean-Christophe Batsale

11 July 2006 in Physical Review B
Verified
Journal Article
Closed access
PDF file
JNJ. Nogués
J. Nogués
EAE. Apiñaniz
E. Apiñaniz
Jordi SortJordi Sort
Jordi Sort
MAM. Amboage
M. Amboage
MDM. D’aStuto
M. D’aStuto
FBF. Baudelet
F. Baudelet
The origin of magnetism in atomically disordered transition-metal–nonmagnetic (i.e., FeAl) alloys has been investigated by dichroism and diffraction measurements at high pressure and by band structure calculations. The results show that, in contrast to earlier studies, besides the effects of the local environment of the magnetic ions, disorder-induced lattice changes play a key role in the magnetic properties of these systems. We demonstrate experimentally and theoretically that about 35–45% of the magnetic moment of Fe60Al40 alloys arises from lattice expansion effects induced during the disordering process. Such large effects in Fe60Al40 could actually be related to the moment-volume instability observed in these alloys.

1 August 2011 in Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
RFRaquel Fuente
Raquel Fuente
EAEstibaliz Apiñaniz
Estibaliz Apiñaniz
AMArantza Mendioroz
Arantza Mendioroz
ASAgustin Salazar
Agustin Salazar
Modulated photothermal radiometry (PTR) has been widely used to measure the thermal diffusivity of bulk materials. The method is based on illuminating the sample with a plane light beam and measuring the infrared emission with an infrared detector. The amplitude and phase of the PTR voltage is recorded as a function of the modulation frequency and then fitted to the theoretical model. In this work, we test the ability of modulated PTR to retrieve simultaneously the thermal diffusivity and the optical absorption coefficient of homogeneous slabs. In order to eliminate the instrumental factor, self-normalization is used, i.e., the ratio of the PTR signal recorded at the rear and front surfaces. The influence of the multiple reflections of the light beam, the heat losses, and the transparency to infrared wavelengths are analyzed. Measurements performed on a wide variety of homogeneous materials, covering the whole range from transparent to opaque, confirm the validity of the method. In Part II of this work, the method is extended to multilayered materials.

1 January 2003 in The European Physical Journal B
Verified
Journal Article
Closed access
PDF file
ENE. Api Naniz
E. Api Naniz
FPF. Plazaola
F. Plazaola
JGJose S. Garitaonandia
Jose S. Garitaonandia

1 August 2011 in Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
ASAgustin Salazar
Agustin Salazar
RFRaquel Fuente
Raquel Fuente
EAEstibaliz Apiñaniz
Estibaliz Apiñaniz
AMArantza Mendioroz
Arantza Mendioroz
RCR. Celorrio
R. Celorrio
The aim of this work is to analyze the ability of modulated photothermal radiometry to retrieve the thermal diffusivity and the optical absorption coefficient of layered materials simultaneously. First, we extend the thermal quadrupole method to calculate the surface temperature of semitransparent multilayered materials. Then, this matrix method is used to evaluate the influence of heat losses by convection and radiation, the influence of the use of thin paint layers on the accuracy of thermal diffusivity measurements, and the effect of lateral heat diffusion due to the use of Gaussian laser beams. Finally, we apply the quadrupole method to retrieve (a) the thermal contact resistance in glass stacks and (b) the thermal diffusivity and optical absorption coefficient depth profiles in heterogeneous materials with continuously varying physical properties, as is the case of functionally graded materials and partially cured dental resins.