30 September 2017 in Materiale Plastice
CRCarmen Otilia Rusanescu
FAFlorina Violeta Anghelina
Florina Violeta Anghelina
+1
In this paper, optimum hot formation processing parameters for 31VMn12 steel were established, the torsion deformation of 31VMn12 steel was investigated at temperatures from 900, 1000, 11000C and strain rates from 0.05 s-1 to 3 s. -1. There were studied the structural aspects of materials, in microstructures by electronic microscopy. The stress level decreases with increasing deformation temperature and decreasing strain rate, which can be represented by a Zenner-Hollomon parameter. The mathematical model presented in the paper describes the relationship of tension strain, voltage and temperature coefficient 31VMn12 steel at high temperatures. The stress-strain curves determined by the torsion test allowed the calculation of the Zenner-Hollomon parameter corresponding to the maximum stress. By using this parameter has established a set of equations that reproduce completely stress-strain curve, including the hardening, the restoration and dynamic recrystallization area. Comparisons were made between the experimental results and the predicted and confirmed that constitutive equations developed can be used for mathematical modelling and other attempts (forging, compression) and other types of steel.
30 August 2013 in Applied Mechanics and Materials
This paper initiates the launch and the integration of a new scientific concept: "Mechatronics Galaxy", a support of industrial research for European sustainable and strategic development. This new concept is based on achievement and development of evolutionary and integrative-synergistic concepts regarding micro-nanomechatronics engineering, micro-nanoelectronics engineering and micro-nanoIT engineering for: spatial, temporal and functional integration;intelligent adaptive behaviour based on perception, self-learning, self-diagnostics and systemic reconfiguration; adequate flexibility of software and hardware structures; predictive development of micro-nano-mechatronics structures and of the intelligent computerized applicability with high added value; simultaneous mix-integrative design of micro-nano-products, micro-nano-systems and micro-nano-technologies; a strategy of technological impact in economy, industry, society and education. Thus, the new concept "Mechatronics Galaxy" creates and develops micro-nano-mechatronics engineering, based on fundamental and applied techniques: micro-nano-mechatronics, micro-nano-robotics, micro-nano-integronics, micro-nano-sensoristics, micro-nano-actuators, micro-nano-processing and intelligent micro-nano-manufacturing.
1 October 2014 in Applied Mechanics and Materials
CCCarmen Adriana Cîrstoiu
The present work aims to investigate the tool-chip interface temperature as functions of cutting parameters and also establishes an equation between the surface roughness and the temperature in the cutting area. Based on the experimental results, there were determined mathematical models, by using the factorial designs combined with the regression techniques.
28 October 2015 in Advanced Materials Research
CCCarmen Adriana Cîrstoiu
For the mathematical modeling of the bending behavior on a microgripper compliant arm it is necessary to estimate the compliance impact on the system. In case of low bending force values, the linear dependence between force and elastic deformation is presumed. After performing bending experiments on full section and, respectively, compliant arms, there was determined an elastic coefficient allowing the mathematical modeling of the compliant beam as a full section beam and a moment of inertia reduced proportionally to the calculated elastic coefficient. The modeling results are consistent with the results of the experiments performed on the prototype.