14 May 2024 in IEEE Transactions on Communications
Distributed Antenna Systems (DASs) employ multiple antenna arrays in remote radio units to achieve highly directional transmission and provide great coverage performance for future-generation networks. However, the utilization of fully digital or hybrid active antenna arrays results in a significant increase in hardware costs and power consumption for DAS. To address these issues, integrating DAS with Reconfigurable Intelligent Surfaces (RIS) offers a viable approach to ensure coverage and transmission performance while maintaining low hardware costs and power consumption. To incorporate the merits of RIS into the DAS from practical consideration, a novel architecture of “Reconfigurable Distributed Antennas and Reflecting Surfaces (RDARS)” is proposed in this paper. Specifically, based on the design of the additional direct-through state together with the existing high-quality fronthaul link, any element of the RDARS can be dynamically programmed to connect with the base station (BS) via fibers and perform the connected mode as remote distributed antennas of the BS to receive or transmit signals. Additionally, RDARS also inherits the low-cost and low-energy-consumption benefits of fully passive RISs by default configuring the elements as passive to perform the reflection mode . As a result, RDARS encompasses both DAS and RIS as special cases, offering flexible control over the trade-off between distribution gain and reflection gain to enhance performance. To unveil the potential of such architecture, the ergodic achievable rate under the RDARS architecture is analyzed and closed-form expression with meaningful insights is derived. The theoretical analysis proves that the RDARS can achieve a higher achievable rate than both DAS and fully passive RIS with the passive beamforming gain provided by elements acting reflection mode while combating the “multiplicative fading” suffered by RISs through the connected mode performed at the RDARS. Simulation results also demonstrate the superiority of the RDARS architecture over DAS and passive RIS-aided systems and its flexible trade-off between performance and cost. To further validate the feasibility and effectiveness, an RDARS prototype with 256 elements is built for real experiments. Experimental results show that the RDARS-aided system with only one element operating in connected mode can achieve an additional 21% and 170% throughput improvement over DAS and RIS-aided systems, respectively.
3 October 2024 in IEEE Transactions on Wireless Communications
Reconfigurable intelligent surface (RIS) has emerged as a cost-effective solution for green communications in 6G. However, its further extensive use has been greatly limited due to its fully passive characteristics. Considering the appealing distribution gains of distributed antenna systems (DAS), a flexible reconfigurable architecture called reconfigurable distributed antenna and reflecting surface (RDARS) is proposed. RDARS encompasses DAS and RIS as two special cases and maintains the advantages of distributed antennas while reducing the hardware cost by replacing some active antennas with low-cost passive reflecting surfaces. In this paper, we present a RDARS-aided uplink multi-user communication system and investigate the system transmission reliability with the newly proposed architecture. Specifically, in addition to the distribution gain and the reflection gain provided by the connection and reflection modes, respectively, we also consider the dynamic mode switching of each element which introduces an additional degree of freedom (DoF) and thus results in a selection gain. As such, we aim to minimize the total sum mean-square-error (MSE) of all data streams by jointly optimizing the receive beamforming matrix, the reflection phase shifts and the channel-aware placement of elements in the connection mode. To tackle this nonconvex problem with intractable binary and cardinality constraints, we propose an inexact block coordinate descent (BCD) based penalty dual decomposition (PDD) algorithm with the guaranteed convergence. Since the PDD algorithm usually suffers from high computational complexity, a low-complexity greedy-search-based alternating optimization (AO) algorithm is developed to yield a semi-closed-form solution with acceptable performance. Numerical results demonstrate the superiority of the proposed architecture compared to the conventional fully passive RIS or DAS. Furthermore, some insights about the practical implementation of RDARS are provided.
26 March 2025 in IEEE Internet of Things Journal
This article presents a novel integrated sensing and communication (ISAC) framework that leverages recent advancements in reconfigurable distributed antennas and reflecting surfaces (RDARS). RDARS is a programmable structure composed of numerous elements, each of which can be flexibly configured to operate in either reflection mode, resembling a passive reconfigurable intelligent surface (RIS), or connected mode, functioning as a remote transmit or receive antenna. Our RDARS-aided ISAC framework effectively mitigates the adverse effects of multiplicative fading compared to passive RIS-aided counterparts and reduces costs and energy consumption relative to active RIS-aided systems. Within this framework, we address a radar output signal-to-noise ratio (SNR) maximization problem by jointly optimizing the active transmit beamforming matrix, the reflection and mode selection matrices of RDARS, and the receive filter, while ensuring communication requirements are met. To tackle the inherent nonconvexity and mixed-integer optimization challenges, we propose an efficient penalty-based iterative algorithm with guaranteed convergence based on the majorization-minimization (MM) framework. Additionally, we present some interesting insights about the mode selection of RDARS by considering a RDARS-aided sensing system. Numerical results demonstrate the superior performance of our framework compared to existing structures, attributed to the distribution, reflection, and selection gains provided by the dynamically configured RDARS.
16 July 2024 in IEEE Transactions on Wireless Communications
Accurate channel state information (CSI) is essential for downlink precoding in frequency division duplexing (FDD) massive multiple-input multiple-output (MIMO) systems with orthogonal frequency-division multiplexing (OFDM). However, obtaining CSI through feedback from the user equipment (UE) becomes challenging with the increasing scale of antennas and subcarriers and leads to extremely high CSI feedback overhead. Deep learning-based methods have emerged for compressing CSI but these methods generally require substantial collected samples and thus pose practical challenges. Moreover, existing deep learning methods also suffer from dramatically growing feedback overhead owing to their focus on full-dimensional CSI feedback. To address these issues, we propose a low-overhead Incorporation-Extrapolation based Few-Shot CSI feedback Framework (IEFSF) for massive MIMO systems. An incorporation-extrapolation scheme for eigenvector-based CSI feedback is proposed to reduce the feedback overhead. Then, to alleviate the necessity of extensive collected samples and enable few-shot CSI feedback, we further propose a knowledge-driven data augmentation (KDDA) method and an artificial intelligence-generated content (AIGC) -based data augmentation method by exploiting the domain knowledge of wireless channels and by exploiting a novel generative model, respectively. Experimental results based on the DeepMIMO dataset demonstrate that the proposed IEFSF significantly reduces CSI feedback overhead by 64 times compared with existing methods while maintaining higher feedback accuracy using only several hundred collected samples.
8 December 2025 in IEEE Transactions on Wireless Communications
Reconfigurable distributed antenna and reflecting surface (RDARS) is a new architecture for the sixth-generation (6G) millimeter wave (mmWave) communications. In RDARS-aided mmWave systems, the active and passive beamforming design and working mode configuration for reconfigurable elements are crucial for system performance. In this paper, we aim to maximize the weighted sum rate (WSR) in the RDARS-aided mmWave system. To take advantage of RDARS, we first design a reconfigurable codebook (RCB) in which the number and dimension of the codeword can be flexibly adjusted. Then, a low overhead beam training scheme based on hierarchical search is proposed. Accordingly, the active and passive beamforming for data transmission is designed to achieve the maximum WSR for both space-division multiple access (SDMA) and time-division multiple access (TDMA) schemes. For the TDMA scheme, the optimal number of RDARS transmit elements and the allocated power budget for WSR maximization are derived in closed form. Besides, the superiority of the RDARS is verified and the conditions under which RDARS outperforms RIS and DAS are given. For the SDMA scheme, we characterize the relationship between the number of RDARS connected elements and the user distribution, followed by the derivation of the optimal placement positions of the RDARS transmit elements. High-quality beamforming design solutions are derived to minimize the inter-user interference (IUI) at the base station and RDARS side respectively, which nearly leads to the maximal WSR. Finally, simulation results confirm our theoretical findings and the superiority of the proposed schemes.
22 October 2024 in IEEE Transactions on Wireless Communications
In this paper, we investigate a novel reconfigurable distributed antennas and reflecting surface (RDARS) aided multi-user massive multiple-input multiple-output (MIMO) system with imperfect channel state information (CSI) and propose a practical two-timescale (TTS) transceiver design to reduce the communication overhead and computational complexity of the system. In the RDARS-aided system, not only distribution gain but also reflection gain can be obtained by a flexible combination of the distributed antennas and reflecting surface, which differentiates the system from the others and also makes the TTS design challenging. To enable the optimal TTS transceiver design, the achievable rate of the system is first derived in closed-form. The rate expression is general and covers that of the distributed antenna systems (DAS) and reconfigurable intelligent surface (RIS) aided systems as special cases. Then the TTS design aiming at the weighted sum rate maximization is considered. To solve the challenging non-convex optimization problem with high order design variables, i.e., the transmit powers and the phase shifts at the RDARS, a block coordinate descent based method is proposed to find the optimal solutions in semi-closed forms iteratively. Specifically, two efficient algorithms are proposed with provable convergence for the optimal phase shift design, i.e., Riemannian Gradient Ascent based algorithm by exploiting the unit-modulus constraints, and Two-Tier Majorization-Minimization based algorithm with closed-form optimal solutions in each iteration. Simulation results validate the effectiveness of the proposed algorithm and demonstrate the superiority of deploying RDARS in massive MIMO systems to provide substantial rate improvement with a significantly reduced total number of active antennas/RF chains and lower transmit power when compared to the DAS and RIS-aided systems.