1 July 2018 in Quarterly Journal of the Royal Meteorological Society
The convective area within a mesoscale convective system (MCS) contains intense convective cells or storms which themselves could be made of a single cumulonimbus cloud or several of them joined together. Interconnection between MCS evolution and storms has not been reported previously. We address this gap area by using the Doppler Weather Radar (DWR) data collected at four stations in India during the summer monsoon season of 2013. The four DWR locations selected have different climates ranging from coastal to semi‐arid. Storm is defined as a set of contiguous radar pixels in three‐dimensional space with a reflectivity threshold of 30 dBZ and the threshold criterion is satisfied in a volume of at least 50 km3. Monsoonal MCSs contain a few to more than 20 storms depending on geographic location and MCS life stage. The average area of storms ranges from 13 to 170 km2 while storm heights mostly lie between 6 and 10 km. The growth stage of an MCS is characterized by a rapid increase in the number of storms, while their number and average area decrease in the dissipation stage. Storms occupy 30–70% of the convective area within an MCS and contribute 90–97% of the convective precipitation at any given instant. Thus, a few to several cumulonimbus clouds grouped together in a contiguous manner matter most for convective precipitation, making storm scale an important scale in the hierarchy of scales in tropical deep convective cloud systems. This has implications for cumulus parametrization as well as planning satellite payloads for observing precipitation.
23 October 2019 in Quarterly Journal of the Royal Meteorological Society
Under the INCOMPASS project, state of the art eddy‐covariance based surface flux measurement systems were installed at eight locations across India. These sites cover different climatic conditions, land use and land cover, and water management practices. Here we present the initial analysis of the measurements taken at seven sites mainly focusing on the year 2017, quantifying for the first time the remarkable contrasts in evaporative fraction across the seasons, climate zones and land management practices of the Indian subcontinent. With the exception of Jaisalmer which is the driest of the places studied, all the sites maintain values of evaporative fraction above 0.5 after the monsoon through to November. By contrast, for those sites with natural vegetation or rain‐fed agriculture, evaporative fraction remains below 0.3 for the dry January–May period. In the middle Gangetic Plain area, irrigation and pre‐monsoon showers together maintain evaporative fraction above 0.5 between January and June. It is also observed that different variables exhibit different intraseasonal variation characteristics even at one site. Except for Samastipur which is situated in the middle Indo‐Gangetic Plains, wind speed shows spectral peak at a smaller time‐scale compared to sensible and latent heat fluxes.
25 July 2020 in Current Science
15 July 2025 in Agricultural and Forest Meteorology
15 May 2008 in Climate Dynamics
16 January 2025 in MAUSAM
Weather radar is an indispensable tool in the continuous monitoring and warning of extreme events including tropical cyclones and thunderstorms. The India Meteorological Department (IMD) has been operating radars since 1949. The evolution of radar meteorology in India may be divided into three broad phases, namely, the 1950s (phase-I), then up to the year 2000 (phase-II), and thereafter (phase-III). During phase-I, radars were imported and installed in cities to aid aircraft operations. Photographs of radar scopes were analysed to provide a broad understanding of temporal evolution and spatial extent of precipitating clouds in different parts of the country and seasons. During phase-II, storm warning (X-band) and cyclone warning (S-band) radars with more power and range were installed, and some of them were indigenous. Phase-III ushered in the era of digital Doppler weather radars in India. Interfacing between numerical models and radars started in phase-III including assimilation of radar winds and model verification. Installation and operation of weather radars outside IMD also started in phase-III. Important areas where more work needs to be done include a well-trained workforce in radar meteorology, radar calibration and data standardization, radar area coverage and networking, algorithms for quantitative precipitation estimation using polarimetric products, assimilation of radar products in numerical models, research on cloud physics and dynamics, applications of AI/ML in storm and severe weather nowcasting.