A robust genetic circuit optimizer using Unscented Transform and Non-dominated Sorting Genetic Algorithm-II is presented. The algorithm provides significant computational cost reduction compared to Monte Carlo method. The Unscented Transform permits circuit performance uncertainties determination from components uncertainties, thus, a search through robustness can be approached. Besides reduced computational effort, a plethora of possibilities offered to circuit designer by the multi-objective search can be observed as result. Doherty power amplifier was used as case study.
This paper deals with the implementation of a RF Doherty Power Amplifier (DPA) with the objective of improving the average efficiency. This technique is an interesting way to provide efficient PA for high PAPR signal of more recent standards of communications. The Doherty principle is applied to a 2.5GHz fully integrated PA on a CMOS 65nm technology. The DPA exhibits 23.4dBm output power, 15dB of power gain and 24.7% of PAE on a 7 dB power range. The die size is 2.89mm2. To fulfill high data rates, wide-band behavior is a big challenge. Hence the wideband behavior of integrated DPA is also investigated.
This paper describes the synthesis method and implementation in 65-nm CMOS technology of a compact analog phase-shifter (PS) dedicated to 24/28 GHz applications. This PS delivers a phase shift continuously tunable from 0 to 55° and is particularly suited for on-chip or in-package phased-array antenna. The proposed topology, which is based on an all-pass circuit that includes coupled microstrip lines and varactors as tunable components is intrinsically compact and shows an interesting phase-range vs capacitance-variation ratio.
This paper aims to present the implementation and validation of a 3D printed Open Source Robotic Arm with 6degrees of freedom and an industrial shape. Unlike the original Open Source Thor design, printed with PLA material, ABSprinted parts were used for their higher mechanical strength. Changes were implemented in the electronic system through the use of two Arduino Mega systems with the Ramps interface cards for controlling all actuators, besides the use of Marlin firmware and Pronterface control software for 3D printers. The torque on the first joint on the base was increased by the addiction of one more stepper motor and the open source project validation wasdone by moving the robot through its working area.
26 November 2014 in Analog Integrated Circuits and Signal Processing