28 September 2017 in IEEE Transactions on Microwave Theory and Techniques
This paper presents the design and measurements of a 32-Gb/s differential-input differential-output transimpedance amplifier (TIA) employed in dual polarization integrated coherent receivers for 100-Gb Ethernet. A circuit technique is shown that uses a replica TIA to stabilize the operating point of the two shunt-feedback input stages as well as to cancel the dc part of the two complementary input currents and balances their offset. The TIA can be operated in two modes, an automatic gain control mode to retain a good total harmonic distortion (THD) over a wide dynamic range and a manual gain control mode. Electrical as well as optical-electrical characterization of the TIA are presented. It achieves a maximum differential transimpedance of 74 dBΩ, 33 GHz of 3-dB bandwidth, 12.2 pA/√Hz of average input-referred noise current density with the photodiode, 900 mVpp of maximum differential output swing, less than 1% of THD for 600 mVpp differential output swing, and 500 μApp differential input current. The linearity of the TIA is furthermore demonstrated with PAM4 measurements at 25 Gbaud. The dual TIA chip is fabricated in a 0.13-μm SiGe:C BiCMOS technology, dissipates 436 mW of power and occupies 2 mm² of area.
25 December 2017 in IEEE Journal of Solid-State Circuits
The design methodology and circuit implementation of a transimpedance (TI) amplifier (TIA) featuring low averaged input-referred current noise density without compromising the TIA bandwidth (BW) are presented. The technology role in the key performance metrics is also discussed and verified by means of two analogous TIA designs implemented in two different 130-nm SiGe:C BiCMOS processes from IHP, SG13S with $f_{T}/f_{\max }= 250/340$ GHz and SG13G2 with $f_{T}/f_{\max }= 300/500$ GHz. Both TIAs adopt a fully differential linear architecture with three stages: an input shunt-feedback TI stage followed by a variable gain amplifier which provides post-amplification with 15-dB gain control range and an output 50- $\Omega $ buffer. The TIA in SG13S features 68.5 dB $\Omega $ differential TI gain, 42-GHz 3-dB BW, and 8 pA/ $\sqrt {\mathrm {Hz}}$ averaged input-referred current noise density while the second TIA in SG13G2 provides 65 dB $\Omega $ differential TI gain, 66-GHz 3-dB BW, and 7.6 pA/ $\sqrt {\mathrm {Hz}}$ . Measured total harmonic distortion in both TIAs in the maximum gain condition is better than 5% for ~800 mVppd output swing and input currents of ~300 $\mu $ App. Both circuits dissipate 150 mW of power and are shown to operate at up to 100 Gb/s data rate with clean PRBS31 non-return to zero and PAM-4 eye diagrams. To the author’s best knowledge, the reported TIAs exhibit the lowest averaged input-referred current noise density shown to date at a BW sufficient to support 100 Gb/s net data rate, surpassing other silicon-based and InP implementations toward the next-generation 400 Gb/s optical links.
16 October 2017 in IEEE Transactions on Microwave Theory and Techniques
In this paper, a linear driver for optical modulators in a 0.13- $\mu \text{m}$ SiGe:C BiCMOS technology with $f_{T}/f_{\text {max}}$ of 300/500 GHz is presented. The design is implemented following a distributed amplifier topology in a differential manner. The driver features a small-signal gain of 12.5 dB and a 3-dB bandwidth of 90 GHz and delivers a maximum output amplitude of $4~V_{\text {pp}}$ to a 100- $\Omega $ differential load. Delivering the maximum output swing, the large-signal gain is 10.5 dB. Time-domain measurements are performed, showing the maximum output swing with ON–OFF keying (OOK) eye-diagrams up to 64 Gb/s and pulse amplitude modulation-4 up to 45 Gbaud (90 Gb/s). Moreover, OOK eye-diagrams up to 120 Gb/s are reported with an output swing of $3~V_{\text {ppd}}$ . Total harmonic distortion measurements are also conducted demonstrating a value of 5% at 1 and 8 GHz up to an input amplitude of 800 mVppd. Using a reduced number of stages in the design, the power dissipation of the integrated circuit is 550 mW, resulting in an output power to power dissipation ratio of 3.6%. To the best knowledge of the authors, this is the first time a linear driver for optical modulators demonstrates such high bandwidth and efficiency for the demonstrated data-rates.
13 December 2017 in IEEE Microwave and Wireless Components Letters
A broadband low-noise amplifier with transimpedance (TI) feedback implemented in a 130-nm SiGe:C BiCMOS technology with fT of 300 GHz is presented. The circuit provides 22-dB gain and 75-GHz bandwidth while dissipating only 95 mW of power, achieving a gain bandwidth against dc power efficiency (GBW/Pdc) of 9.9 GHz/mW. Measured noise figure (NF) is 4 dB until 26.5 GHz, rising up to 6 dB at 70 GHz based on simulation. Ultrahigh data rate support is demonstrated with clear eye diagrams up to 100 Gb/s. Intended as a TI front end for optical receivers, the amplifier features 54-dBΩ TI gain with only 10.9 pA/√ Hz averaged input-referred current noise density. Measured input-referred 1-dB compression point at 1 GHz occurs at -20 dBm input power. To the best of the authors' knowledge, the proposed amplifier exhibits the highest GBW/Pdc with the lowest NF reported to date, toward the next generation 400 Gb/s Ethernet.
12 February 2018 in IEEE Microwave and Wireless Components Letters
Stacked power amplifiers (PAs) have gained a lot of attention recently because of increased output power through equal distribution of output voltage swing among the stacked transistors. However, commonly employed PA design techniques, such as waveform engineering or harmonic tuning, often suffer in stacked configuration, and the enhancement in power-added efficiency (PAE) remains poor. This letter analyzes the feasibility of harmonic tuning techniques applied to stacked amplifiers. An analysis is presented to show how harmonic tuning at the output affects harmonic optimization of stacked transistors and how this depends on the base termination impedance. Three different device configurations (cascode, tri-stacked, and quad-stacked) have been characterized at $X$-band. Measured results show harmonic PAE enhancement degrades as the number of stacked transistors increases, which is in agreement with the analysis presented.
21 March 2018 in IEEE Solid-State Circuits Letters
A 27-1 pseudo-random bit sequence (PRBS) generator, implemented in a 130-nm SiGe:C BiCMOS technology with fT/fmax of 300/500 GHz, is presented. The generator uses a modified half-rate clock topology which enables it to operate at data rates up to 115 Gb/s with low power consumption. Time-domain measurements are performed to demonstrate the maximum data rate of the circuit, which delivers a differential output voltage swing of 600 mVpp and dissipates 700 mW. Spectrum measurements are also carried out to validate the generated PRBS sequence. To the best knowledge of the authors, this is the first time a PRBS generator achieves such data rate with a record efficiency of 0.87 pJ/b.