In RF transceivers operating in carrier-aggregation, spurs are generated on the transceiver chip which may down-convert any blocker signal located at the spur frequency into the receiver baseband. The blocker signal could either be the transceiver's own transmit signal when operating in frequency-division duplex, or a WiFi-related signal received by the antenna. This so-called modulated spur interference contains the phase-noise (PN) of the involved local oscillator harmonics which created the spur and leads to a degradation of the wanted RX signal. The presented mixed-signal circuit mimics the spur building law including the PN of the harmonics and is, therefore, able to provide a replica of the spur interference including PN modulated components. This replica is then used as a reference signal for the digital cancellation of the main and image modulated spur interference using a widely-linear (WL) cancellation structure. The proposed circuit technique is implemented in 28 nm LP CMOS technology, and measurement results show that the mixed-signal solution outperforms a digital-only WL cancellation with respect to PN cancellation even with high blocker power levels of -15 dBm at the input of the low-noise amplifier.
In frequency division duplex transceivers, the limited transmitter-to-receiver duplexer stop-band isolation causes a leakage signal from the transmitter into the receiver. In combination with a finite second-order input intercept point (IIP2), this leads to a second-order intermodulation distortion (IMD2) self-interference in direct conversion architectures which desensitizes the receiver. This IMD2 interference always falls directly into the baseband independent of the frequency offset between transmitter and receiver. In this contribution a nonlinear least-mean-squares type adaptive filter to cancel the transmitter induced IMD2 self-interference is developed which is suitable for highly frequency-selective duplexer stop-bands. The proposed solution outperforms existing adaptive Volterra kernel based algorithms despite its low computational complexity.
27 August 2019 in IEEE Transactions on Circuits and Systems II: Express Briefs
Due to the use of wide-band analog front-ends in order to cover the many different frequency bands used in Long Term Evolution (LTE), blocker signals received by the antenna may reach the mixer input. As a consequence, squarewave mixer implementations, as e.g. the 25% duty-cycle currentdriven passive mixer, may lead to the down-conversion of these blocker signals by their harmonic response. This contribution describes a harmonic rejection (HR) strategy, which modifies the local oscillator (LO) waveform of a 25% duty-cycle currentdriven passive mixer, to suppress specific harmonics. Two HR control signal waveforms are proposed and their performance is evaluated by circuit simulations using a 28nm CMOS technology. By applying the proposed concept, the down-conversion of a blocker by the mixer’s 3rd order harmonic response can be suppressed by more than 30 dB, and the receiver noise figure (NF) is improved by 21.1 dB for a blocker power of -5dBm at the low-noise amplifier (LNA) input.