This study proposes a new method for measuring thermal contact resistance using lock-in thermography. By using lock-in thermography with an infrared microscope, the dynamic and spatially resolved temperature behavior of the contact interface was visualized on a microscale with one measurement. In addition, a new thermal contact resistance measurement principle was constructed after solving the three-dimensional thermal conduction equation in the cylindrical coordinates by considering a periodic heat source with a Gaussian intensity distribution and the relative position of the heating point to the sample edge, in the presence of thermal resistance at the contact interface. Consequently, the discontinuous behaviors of the temperature wave, amplitude, and phase lag at the contact interface were observed on a microscale. From that discontinuity, the local thermal contact resistance was analyzed as a fitting parameter by matching the theoretical curve to the measured amplitude and phase lag. Furthermore, the simultaneous analysis of the material thermal diffusivity was demonstrated and the validity of the measurements was confirmed.
5 October 2022 in International Journal of Thermophysics
We propose a versatile method for measuring the thermophysical properties of composites by means of lock-in thermography (LIT) technique. The method is based on analyzing the thermal response distribution induced by periodic laser heating, which enables simultaneous high-spatial-resolution mapping of the effective out-of-plane thermal diffusivity, thermal conductivity, and volumetric heat capacity over the surface of the material. We validate the method using a reference material and demonstrate its capability in visualizing the effective properties of laminated carbon fiber reinforced plastic and carbon fiber reinforced thermoplastic with discontinuous fibers. The results showed that the LIT-based approach has high reproducibility and sensitivity, which allows observing the effect of fiber orientations on the effective properties. The proposed method will be useful for thermal research in composites, defect detection, and for investigating component geometric arrangement effects on the thermophysical properties.
Transient response of the spin Peltier effect (SPE) in a Pt/yttrium iron garnet junction system has been investigated by means of a lock-in thermoreflectance method. We applied an alternating charge current to the Pt layer to drive SPE through the spin Hall effect, and measured the AC response of the resultant SPE-induced temperature modulation at frequencies ranging from 10 Hz to 1 MHz. We found that the SPE-induced temperature modulation decreases with increasing the frequency when the frequency is . This is a characteristic feature of SPE revealed by the high frequency measurements based on lock-in thermoreflectance, while previous low frequency measurements showed that the SPE signal is independent of the frequency. We attribute the decrease of the temperature modulation to the length scale of the SPE-induced heat current; by comparing the experimental results with one-dimensional heat conduction calculations, the length scale of SPE is estimated to be 0.94 μm.