19 November 2013 in IEEE Transactions on Microwave Theory and Techniques
In this paper, a prototype automotive radar sensor is presented that is capable of generating simultaneously multiple transmit (TX) beams. The system is based on a four-channel 77-GHz frequency-modulated continuous-wave (FMCW) radar system. The number of beams, their radiated power, steering angle, and beam pattern can be changed adaptively. This is achieved by the utilization of orthogonal waveforms applied to different beams in combination with digital beamforming on the receive side. Key components are vector modulators in the TX path controlled by digital-to-analog converters. The performance of the system is shown in measurements focused on beam pattern, signal-to-noise ratio, and susceptibility in case of interfering targets at cross-range. Measurement results are discussed and compared to theory and simulations. Furthermore, crest factor minimization of the vector modulator's control signals is introduced and used to increase the achievable TX power, which will be also shown in measurements.
31 January 2012 in IEEE Transactions on Microwave Theory and Techniques
This paper presents a multi-channel frequency-modulated continuous-wave (FMCW) radar sensor operating in the frequency range from 91 to 97 GHz. The millimeter-wave radar sensor utilizes an SiGe chipset comprising a single signal-generation chip and multiple monostatic transceiver (TRX) chips, which are based on a 200-GHz fT HBT technology. The front end is built on an RF soft substrate in chip-on-board technology and employs a nonuniformly distributed antenna array to improve the angular resolution. The synthesis of ten virtual antennas achieved by a multiple-input multiple-output technique allows the virtual array aperture to be maximized. The fundamental-wave voltage-controlled oscillator achieves a single-sideband phase noise of -88 dBc/Hz at 1-MHz offset frequency. The TX provides a saturated output power of 6.5 dBm, and the mixer within the TRX achieves a gain and a double sideband noise figure of 11.5 and 12 dB, respectively. Possible applications include radar sensing for range and angle detection, material characterization, and imaging.