Tidal stream energy is acquiring more attention as a future potential renewable energy source. Considering the harsh submarine environment, the main challenges that face the tidal stream turbine (TST) industry are cost and reliability. Hence, simple and reliable technologies, especially considering the drivetrain, are preferred. The multibrid drivetrain configuration with only a single stage gearbox is one of the promising concepts for TST systems. In this context, this paper proposes the design optimization of a multibrid permanent magnet generator (PMG), the design of a planetary gearbox, and afterwards analyzes the multibrid concept cost-effectiveness for TST applications. Firstly, the system analytical model, which consists of a single-stage gearbox and a medium speed PMG, is presented. The optimization methodology is afterwards highlighted. Lastly, the multibrid system optimization results for different gear ratios including the direct-drive topology are discussed and compared where the suitable gear ratio (topology) is investigated. The achieved results show that the multibrid concept in TST applications seems more attractive than the direct-drive one especially for high power ratings.
1 November 2026 in IEEE Transactions on Applied Superconductivity
High temperature superconducting (HTS) flux pumps have emerged as a promising contactless method for magnetizing closed HTS magnets. These systems rely on HTS switches, which operate through the principle of dynamic resistance, which is a phenomenon where a voltage is induced along a type II HTS tape carrying a direct current (DC) when exposed to a changing magnetic field. While this effect is well known, conventional methods using alternating current (AC) sinusoidal magnetic fields often require demanding conditions, such as high amplitudes and frequencies of applied field to attain high values of dynamic resistance. In this work, we explore a novel approach to generating dynamic voltage in HTS tapes carrying DC transport current by employing pulsed magnetic fields (PMF). To investigate this approach, an experimental bench was designed and implemented to measure the dynamic voltage under these conditions. Additionally, a two-dimensional (2D) electromagnetic thermal coupled model, based on the finite element method, was used to check out the measured quantities.