19 February 2021 in Journal of Electronic Packaging
Three-dimensional (3D) stacked integrated circuit (SIC) chips are one of the most promising technologies to achieve compact, high-performance, and energy-efficient architectures. However, they face a heat dissipation bottleneck due to the increased volumetric heat generation and reduced surface area. Previous work demonstrated that pin-fin enhanced microgap cooling, which provides fluidic cooling between layers could potentially address the heat dissipation challenge. In this paper, a compact multitier pin-fin single-phase liquid cooling model has been established for both steady-state and transient conditions. The model considers heat transfer between layers via pin-fins, as well as the convective heat removal in each tier. Spatially and temporally varying heat flux distribution, or power map, in each tier can be modeled. The cooling fluid can have different pumping power and directions for each tier. The model predictions are compared with detailed simulations using computational fluid dynamics/heat transfer (CFD/HT). The compact model is found to run 120–600 times faster than the CFD/HT model, while providing acceptable accuracy. Actual leakage power estimation is performed in this codesign model, which is an important contribution for codesign of 3D-SICs. For the simulated cases, temperatures could decrease 3% when leakage power estimation is adopted. This model could be used as electrical-thermal codesign tool to optimize thermal management and reduce leakage power.
14 October 2014 in IEEE Transactions on Components, Packaging and Manufacturing Technology
A novel large-scale silicon system platform is proposed and demonstrated. In this paper, three silicon interposer tiles are aligned and mounted on a printed wiring board (PWB), and two silicon bridges are aligned and mounted on top of the three interposer tiles; each silicon bridge spans two interposer tiles. Four positive self-alignment structures and four inverted pyramid pits self-align a tile to the PWB and a bridge to two tiles. Mechanically flexible interconnects (MFI) form nonbonding electrical connections between the three interposer tiles and two silicon bridges; MFIs are fabricated on the interposer tiles. Pointy tips on the MFIs form low contact resistance with the pads on the silicon bridges. Less than 4 μm alignment error is demonstrated on a stack of silicon substrates, and <;8μm alignment error between a silicon bridge and tiles is also demonstrated on a FR4 substrate. Daisy chain and four-point measurements are performed to verify electrical connections between the three interposer tiles via MFIs and silicon bridges.
22 February 2023 in bioRxiv
Neurons coordinate their activity to produce an astonishing variety of motor behaviors. Our present understanding of motor control has grown rapidly thanks to new methods for recording and analyzing populations of many individual neurons over time. In contrast, current methods for recording the nervous system’s actual motor output – the activation of muscle fibers by motor neurons – typically cannot detect the individual electrical events produced by muscle fibers during natural behaviors and scale poorly across species and muscle groups. Here we present a novel class of electrode devices (“Myomatrix arrays”) that record muscle activity at unprecedented resolution across muscles and behaviors. High-density, flexible electrode arrays allow for stable recordings from the muscle fibers activated by a single motor neuron, called a “motor unit”, during natural behaviors in many species, including mice, rats, primates, songbirds, frogs, and insects. This technology therefore allows the nervous system’s motor output to be monitored in unprecedented detail during complex behaviors across species and muscle morphologies. We anticipate that this technology will allow rapid advances in understanding the neural control of behavior and in identifying pathologies of the motor system.