Angel Manuel Galvez-Limaco

Angel Manuel Galvez-Limaco

Auto-generated profile, based on publicly available information

Angel Manuel Galvez-Limaco

Department of Electrical Engineering, São Paulo State University, Ilha Solteira 15385-000, Brazil

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
27 May 2020 in IEEE Sensors Journal
Verified
Journal Article
Closed access
AGAngel Manuel Galvez-Limaco
Angel Manuel Galvez-Limaco
JGJose Galeti
Jose Galeti
ENEmílio Carlos Nelli Silva
Emílio Carlos Nelli Silva
RHRicardo Tokio Higuti
Ricardo Tokio Higuti
MCMichael J. Connelly
Michael J. Connelly
CKClaudio Kitano
Claudio Kitano
An efficient and cost effective optical phase detection vibrometer based on a modified closed loop homodyne Michelson interferometer is presented. Real-time phase demodulation is carried out, using an embedded platform that performs data acquisition, signal processing, PI (proportional-integral) control and the generation of signals that drive the electrooptic Pockels cell phase shifter and the piezoelectric actuator under test. Two phase quadrature signals are generated from a single interferometric output, using the interleaving action, in alternation, of a digitally generated modulating signal, and then the wellknown differential-cross-multiplication technique is applied to perform the computation of the phase shift of interest. The quadrature condition is reached using the PI loop based on an error signal obtained from a Lissajous figure derived from out-of-phase signals. The vibrometer is capable of measuring nanometric displacements, and is simple, inexpensive, accurate, immune to fading and self-consistent. The new method was used to determine the displacement frequency response curves of two prototypes of multi-actuated flextensional piezoelectric actuators. Measurements were made between 500 Hz and 15 kHz, and the results agreed with those obtained by the standard SCM-Signal Coincidence Method.