Additively manufactured continuous fiber-reinforced thermoplastic (CFRTP) composites are still in the early stages of reaching competitive mechanical properties compared with conventional composites. The main reason for this is that their mechanical properties are limited due to weak interlayer strength, porosity, and low fiber fraction. Therefore, the effects of many parameters, such as layer thickness, temperature, printing speed, and fiber fraction, have been extensively studied to improve mechanical properties. With a different perspective on these parameters, this study aimed to investigate the effect of fiber bundle size on the mechanical properties of CFRTP composites. For this purpose, 3K and 6K fiber bundle filaments with the same fiber volume fractions (∼41%) were produced utilizing a polymer impregnation setup. CFRTP samples were printed using fused deposition modeling with polylactic acid as the matrix. The mechanical properties were investigated via three-point bending, interlaminar shear strength (ILSS), and tensile tests. The results showed that fiber bundle size does not particularly influence tensile strength but dominates flexural and ILSS performance. Although increased flexural strength and modulus were observed, the bundle size effect was much more dominant in ILSS tests, and 6K bundle size samples with the same fiber fraction showed much higher strength.
This study investigated the effects of different heat treatments on continuous fiber-reinforced thermoplastic (CFRTP) 's. CFRTP composite is produced using fused deposition modeling (FDM), which is one of the additive manufacturing methods. Polylactic acid (PLA) was used as a matrix, and carbon fibers (3K) were utilized as reinforcement material. First, CFRTP filament was produced on a specially designed melt impregnation line. Afterward, test samples were manufactured via a conventional 3D printer. Then, heat treatments (re-melting in salt, microwave oven, oven) were applied to the produced samples, and the effects of these processes on mechanical properties were investigated. Three-point bending tests were used to investigate the mechanical properties of the test samples. As a result of the heat treatments applied to the CFRTP specimens, flexural stresses between 200 and 220 MPa was achieved. The highest bending stress was obtained by re-melting in salt. As a result of the heat treatments, the stress values are similar, but the re-melting in salt application exhibited a more rigid behavior.
14 May 2025 in International Journal on Interactive Design and Manufacturing (IJIDeM)