Au-containing nanolaminated carbides Mo2AuC and Mo2(Au1−xGax)2C were synthesized by a thermally induced substitutional reaction in Mo2GaC and Mo2Ga2C, respectively.
The magnetic properties of the new phase (Cr0.5Mn0.5)2AuC are compared to the known MAX-phase (Cr0.5Mn0.5)2GaC, where the former was synthesized by thermally induced substitution reaction of Au for Ga in (Cr0.5Mn0.5)2GaC. The reaction introduced a lattice expansion of ∼3% along the c-axis, an enhancement of the coercive field from 30 mT to 140 mT, and a reduction of the Curie temperature and the saturation magnetization. Still, (Cr0.5Mn0.5)2AuC displays similar features in the magnetic field- and temperature-dependent magnetization curves as previously reported magnetic MAX phases, e.g., (Cr0.5Mn0.5)2GaC and (Mo0.5Mn0.5)2GaC. The work suggests a pathway for tuning the magnetic properties of MAX phases.
The first Fe-based MAX phase is realized by solid-state substitution reaction of an Fe/Au/Mo2GaC thin-film diffusion couple, as determined by X-ray diffraction and scanning transmission electron microscopy. Chemical analysis together with elemental mapping reveals that as much as 50 at.% Fe on the A site can be obtained by thermally induced Au and Fe substitution for Ga atomic layers in Mo2GaC. One-sixth of the original Ga is also replaced by Au atoms. When annealing Mo2GaC thin films covered with Fe only, the Mo2GaC phase remains intact, that is, Au acts as a catalyst for the substitution reaction. IMPACT STATEMENT The first direct evidence showing Fe-containing MAX phase, Mo2AC, with Fe ∼50 at.% on the A sites is presented, synthesized by thermally induced Fe and Au substitution reaction catalyzed by Au. GRAPHICAL ABSTRACT
A theoretical and experimental study on the growth and properties of a ternary carbon-based material, CS x F y , synthesized from SF 6 and C as primary precursors is reported. The synthetic growth concept was applied to model the possible species resulting from the fragmentation of SF 6 molecules and the recombination of S–F fragments with atomic C. The possible species were further evaluated for their contribution to the film growth. Corresponding solid CS x F y thin films were deposited by reactive direct current magnetron sputtering from a C target in a mixed Ar/SF 6 discharge with different SF 6 partial pressures ( ). Properties of the films were determined by x-ray photoelectron spectroscopy, x-ray reflectivity, and nanoindentation. A reduced mass density in the CS x F y films is predicted due to incorporation of precursor species with a more pronounced steric effect, which also agrees with the low density values observed for the films. Increased leads to decreasing deposition rate and increasing density, as explained by enhanced fluorination and etching on the deposited surface by a larger concentration of F/F 2 species during the growth, as supported by an increment of the F relative content in the films. Mechanical properties indicating superelasticity were obtained from the film with lowest F content, implying a fullerene-like structure in CS x F y compounds.