Correlation is a fundamental operation in radar/ communication signal processing. Enabling efficient reconfigurable correlation at high frequencies with wide bandwidths and high dynamic range is a fundamental challenge. This article presents a direct-RF wideband analog correlator that utilizes a novel margin computation paradigm replacing traditional multiply-and-accumulate (MAC) with analog addition and thresholding to enable energy-efficient analog computation. A high-efficiency charge-domain realization is proposed and implemented in 65-nm CMOS occupying 0.97 mm2. The analog correlator IC supports 5-GS/s inputs, a large correlation length of 1024, and 8-bit computing accuracy with a high energy efficiency of 152 TOPS/W. Practical applications of typical high-speed correlation are also demonstrated through system-level measurements such as radar signal detection, and code-domain processing.
8 February 2024 in IEEE Journal of Solid-State Circuits
Mitigating self-interference (SI) is vital for advancing simultaneous transmit and receive (STAR) systems. The noise and linearity of the canceller impose limitations on SI power handling. This article proposes a novel dual-path SI cancelling scheme for high-power SI handling. The proposed approach breaks self-interference cancellation (SIC) tradeoffs between operating frequency, SI power handling, and canceller noise/distortion by using a frequency-translated (FT) SI canceller and an auxiliary FT noise-cancelling (NC) path that cancels the noise/distortion from the primary canceller. This approach can work well for both full-duplex (FD) and frequency-division duplex (FDD) schemes. The 65-nm CMOS implementation achieves ~45-dB SIC for 12-dBm receiver (RX) SI peak power (9-dBm avg.) with only 4-dB noise figure (NF) degradation and 207-mW power consumption at 600 MHz. The SIC approach enables a blocker-1 dB with respect to SI of > 16 dBm ( $8\times $ higher than prior work) while operating from 0.5 to 1.3 GHz. Therefore, this implementation can support watt-level SI power handling with transmitter (TX)–RX isolation > 15 dB. This is demonstrated through measurements that show 30-dBm TX power handling with 22-dB initial isolation from the circulator.
A low power high-resolution time-to-digital converter (TDC) is presented. It utilizes a novel multi-path delay line to achieve a sub-gate delay resolution while consuming low power. An offset calibration scheme is also introduced to cancel offsets of both the delay line and the flip-flop. The proposed TDC is designed and simulated in 40nm technology. It achieves 2ps resolution and 1.5ps peak-integral non-linearity (INL) while drawing 100uA from 1.1V supply at 50MHz input frequency.
11 September 2025 in IEEE Journal of Solid-State Circuits
We present a fully analog, multiplier-free, sampled-domain RF correlator to achieve high energy efficiency for radar workloads. The RF correlator employs a split-source follower architecture that leverages the margin propagation (MP) computing paradigm in the sampled domain. As a proof of concept, we implement a $256 \times 256$ fully analog cross correlator in a 22 nm SOI-CMOS process. Large analog delays are realized using a sampling-based approach, and the design incorporates a compact, power and area-efficient four-transistor compute cell. The fabricated IC achieves: 1) input and template data rates up to 4GS/s; 2) single-shot 256-point cross correlations across 256 lags, enabling full $256 \times 256$ cross correlation; 3) >8 bit compute accuracy; 4) energy efficiency of 1000 1b-TOPS/W and 5) compute density of 1.3 1b-TOPS/mm2 per cell. The MP correlator demonstrates robust performance across process–voltage–temperature (PVT) variations and is deployed in a code-domain radar system with multi-user operation, validating system-level feasibility.